Abstract:The inverter-fed motor is a key component of environmental-friendly hybrid cars, high-speed trains, and other industrial applications. After the widespread use of inverter-fed motors, the repetitive impulse surges from inverters were found to cause new insulation problems in inverter-fed motors that were linked to premature insulation failure. The partial discharge (PD) induced by the overvoltage inner stator windings was found to be the root cause of insulation reliability problems. To mitigate this problem, PD detection and life testing at repetitive square voltages should be performed on new types of insulation models and entire motor insulation systems. The obtained partial discharge inception voltage (PDIV) and lifetime of insulation in the tests can be used to evaluate the insulation status of inverter-fed motor insulation systems and thus to improve the insulation designs. At AC voltage conditions, the voltage frequency can significantly affect PD activity. At repetitive square voltage with rapid rise time, the influence of the square voltage frequency on PD activity should be investigated (1) to suggest values for the repetitive square voltage frequency selection for the PDIV and lifetime tests, and (2) to increase the signal-to-noise ratio when extracting PD pulses from strong disturbances generated by the operating switch of impulse generators. Therefore, the main purpose of this paper was to investigate the effects of repetitive square voltage frequency on PD events. Insulation models of both Type I (low-voltage inverter-fed motor) and Type II (high-voltage inverter-fed motor) were used to obtain single-PD and multi-PD statistical features, respectively. Experimental results indicated that higher frequencies caused less PD events with lower PD magnitudes and shorter delay times in one square voltage cycle. This phenomenon was attributed to the different surface charge decay ratios and the initial electron emission probabilities resulting from different square voltage frequencies. Finally, a number of considerations for PD measurements on inverter-fed motors were provided to improve the sensitivity of the PD test system and to obtain high objective insulation lifetime test results, which are used to assess the insulation status of inverter-fed motors.

Aging Time Effect on PD Characteristics under Continuous Pulse Voltage

Analysis of Aging Properties for Insulation Based on Statistical Parameters of Partial Discharge Under Pulse Voltage

Study on Aging Characteristics for Inverter-Fed Traction Motor Inter-Turn Insulation Based on Analysis of Dielectric Characteristic Parameters

Phase Distribution Characteristics of Partial Discharge under Square Pulse Voltage

Research On Aging Characteristics Of Twisted Pair Based On Dielectric Loss Under High Frequency Pulse Voltage

Effect of Repetitive Square Voltage Frequency on Partial Discharge Features

Aging Characteristics of Inverter-fed Motor Twisted Pair Using Tanδ

Statistical Analysis of PD Pulse Occurring in XLPE Insulation During Its Electrical Aging

Investigation On Aging Mechanism Of Winding Insulation Used In Inverter-Fed Traction Motors

Aging Characteristics Analysis of Inter-turn Insulation Using Dielectric Loss

Study on Insulation Aging Properties of Magnet Wire under PWM Voltages

Transition Of Partial Discharge Behavior With Aging Under Square-Wave Ac Voltage

Study on the Development of PD Parameters During the Process of Multi-Stress Aging of Stator Winding

Measurement for Partial Discharge and Analysis on Insulation Aging under Continuous Square Pulse Voltage

Pd Pulse Burst Characteristics in Differently Aged Transformer Oils under Ac Conditions

Experimental Study on Partial Discharge in XLPE Insulation During Electrical Aging

Microscopic View of Aging Mechanism of Polyimide Film under Pulse Voltage in Presence of Partial Discharge

Study on Aging Characteristics of Insulation in Inverter-fed Traction Motor Based on Dielectric Loss

PDC and PD Pulse Burst Characteristics in differently aged Transformer Oils

Study of Partial Discharge Characteristics at Repetitive Square Voltages Based on UHF Method

Partial Discharge Aging of Epoxy Insulation at Different High-Frequency Pulse Parameters and Environmental Stresses