Abstract:This paper is focused on a dual-loop current control method (grid current loop and fundamental current loop) for digitally controlled LCL-type shunt active power filters (APFs). Normally, a proportional-resonant (PR) unit is used as the fundamental current controller, where the proportional part of PR unit actually serves as the proportional feedback of inverter-side current and provides a certain degree of damping for LCL resonance. However, its valid damping region is only up to one-sixth of the sampling frequency (fs/6), which leads to less robustness to the grid impedance. To address this issue, a delay-compensation control link is proposed in this paper to replace the proportional part of the PR fundamental current controller and widen the effective damping region. As a result, the system robustness is improved without adding extra sensors or introducing an extra active damping loop. Theoretical analysis proves that it can obtain a wider damping region of (0, fs/4). Moreover, a systematic controller parameter design criterion is studied. In particular, a numerical optimization algorithm is developed to optimize damping property, and a design method based on root locus plot and Bode diagram is presented to enhance harmonic compensation accuracy. Finally, experimental results implemented on a 30 kVA APF prototype have validated the feasibility of the proposed current controller and parameter design criterion.

Fuzzy Proportional Repetitive Control for Current Tracking of Hybrid Active Power Filter

High-Performance Resonant Controller For Active Power Filter With Selective Harmonic Compensation

High precision compensation for high power Hybrid Active Power Filter based on repetitive control algorithm

Research on PI and Repetitive Control Strategy for Shunt Active Power Filter with LCL-filter

A Current Control Method for LCL Active Power Filters Based on the Reduced Order Generalized Integrator

A Robust Dual-Loop Current Control Method with a Delay-Compensation Control Link for LCL-Type Shunt Active Power Filters

A repetitive-based controller for a hybrid filter with high quality grid current waveform

Dual-repetitive Control Algorithm for Three-Phase Shunt Active Power Filters

Design and implementation of compound current control strategy for improved LCL-based Shunt Active Power Filter

Active Power Filter for Harmonie Compensation Using a Digital Dual-Mode-structure Repetitive Control Approach

Current Loop Control Approach for LCL-based Shunt Active Power Filter

New Hybrid Active Power Filter with Low Additive Reactive Current Injection

The Design and Research of the Hybrid Active Power Filters

A waveform control technique for high power Shunt Active Power Filter based on repetitive control algorithm

Study on a transformerless Hybrid Active Power Filter with high compensation precision and dynamic performance

A Novel Control Approach for LCL-based Shunt Active Power Filter with High Dynamic and Steady-State Performance

A New Hybrid Active Power Filter Topology with Continuous Compensation Bandwidth and Small Active Capacity

Fast-Transient Repetitive Control Strategy for A Three-Phase Lcl Filter-Based Shunt Active Power Filter

Design of DC-bus voltage controller for HAPF using low-pass filter

A current source with one-cycle control and its application in serial hybrid active power filter

Digital Generalized Integrators of Current Control for Three-Phase Active Power Filter with Selective Harmonic Compensation