Abstract:The mode of fuel management of the HTR-10 was studied, including the simulation of the fuel shuffling process and the measurement of the burnup, of a fuel element. The prior consideration was the design of the equilibrium state. Based on this the fuel loading of the initial core and the fuel shuffling mode from the initial core through the running-in phase into the equilibrium state were studied. The code system VSOP was used for the physical layout of the HTR-10 at the equilibrium state and in the running-in phase. For the equilibrium state, in order to lessen the difference between the peak and the average burnup, 5-fuel-passage-through-the-core was chosen for the fuel management. The average burnup of the spent fuel for the equilibrium core is 80 000 MWd t (-1), and the peak value of it is less than 100 000 MWd t (-1) when the burnup of the recycled fuel element is under 72 000 MWd t (-1). The mixture of fuel element and graphite element was used for the initial core loading, the volume fractions of the fuel and the graphite elements were 0.57 and 0.43, respectively. During the running-in phase, the volume fraction of graphite will decrease with the fresh fuel elements being loaded from the top of the core and the graphite elements discharged from the bottom of the core. The fuel shuffling mode is similar to that of the equilibrium state. The burnup limit of recycled fuel element is also 72 000 MWd t - 1 and the peak burnup is less than 100 000 MWd t (-1). Finally the core will be full of fuel elements with a certain profile of burnup and reaches the equilibrium state. According to the characteristics of the pebble-bed high temperature gas-cooled reactor, a calibrating method of concentration of (CS)-C-137 was proposed for the measurement of fuel burnup. (C) 2002 Elsevier Science B.V. All rights reserved.

Improvement on counter circuit of 10MW HTR fuel handling system

Study on Optimization of PID for Feed-water Control System of RB Test in PWR Nuclear Power Station

Design and simulation of TRT top gas pressure control system

A Method of Resonant Frequency Optimized Selection for a SP Inductive Coupled Power Transfer System

Design on HTR-10 Digital Operation Instrumentation and Control System Updating

Parameter Optimization of Detecting Coil Design for Fuel Ball Counter in High Temperature Gas-Cool Reactor

Digital Signal Processing on the Fuel Ball Counting System for HTR-10

Real-time Processing on the Fuel Ball Counter Signals in the 10 MW High Temperature Gas-cooled Test Reactor

Integrated Parameter Mapping and Real-Time Optimization for Load Changes in High Temperature Gas-Cooled Pebble Bed Reactors

Design of a New Temperature Compensating System for High Power Circulator of EAST LHCD System

Dynamic simulation and optimization of load change operation of high-temperature gas-cooled reactor pebble-bed module

An adaptive MA algorithm for significant load changes in HTR-PM

Unit Load and Combustion Control Optimization Based on Radiation Energy Signals

Optimization Design of Eddy Current Sensor for Fuel Balls Detection of HTGR Based on Electromagnetic Field Simulation

Fuel Management of the HTR-10 Including the Equilibrium State and the Running-in Phase

Fuel Management of HTR-10

Design Scheme on Distributed Control System of HTR-10

Design and Tests for the HTR-10 Control Rod System

ICONE19-43911 THE SIMULATION ON THE RUNNING-IN PHASE OF THE HTR-10

Study on dynamic characteristics of HTR-10 at full power operation

Design and Engineering Verification of HTR-PM Fuel Handling