Abstract:The paper investigates the phenomenon of the aeroelastic response of flexible thin airfoils under various angles of attack (AOAs) and flow velocities through wind tunnel experiments and numerical simulations. The vibration modal characteristics are explored, including vibration frequencies, amplitudes, modal transition, and instantaneous characteristics. Vibration is directly measured using non-contact laser sensors, and the numerical model is appropriately configured to simulate the fluid–structure interaction (FSI) problem under large deformation. Experiments cover a range of AOAs (1°–20°) and incoming velocities (from 10 to 73 m/s), with dynamic responses measured using four laser sensors. Both average and instantaneous modal response features are analyzed, revealing multi-modal characteristics as velocity and AOA increase. The vibration mode transitions from pure bending to higher-order modes as incoming velocity increases. Specifically, at higher velocities and increased AOA, the high-order vibration component shifts from bending-torsional coupled mode to pure-torsional mode. Comparison of vibration frequencies between experimental measurements and finite element method simulations highlights significant shifts, particularly in the pure-torsional mode. Furthermore, employing commercial software ANSYS CFX and ANSYS Mechanical, a two-way three-dimensional FSI model successfully replicates flutter boundaries observed experimentally at 1° AOA and approximately incoming velocity 73 m/s. This FSI model is extended to simulate the multi-modal vibrations at 15° AOA, yielding insights into flow phenomena contributing to multi-modal vibration at this AOA. An explanation is provided for the multi-modal vibration phenomenon observed in the experiments based on the above insight. Finally, the differences between the experimental and numerical simulations are speculated upon.

Comparison of Three Aeroelastic State-space Modeling Methods

State Space Model of Unsteady Aerodynamics and Its Application to Aero-servo-elasticity

Aeroelastic Modeling Using Geometrically Nonlinear Solid-Shell Elements

Further Study on Aeroelastic Response of Aircraft Wing with Freeplay

Longitudinal Aerodynamic Coefficients Modeling from Simulated Flight Data of Fixed Wing Aircraft Based on Three Methods

Establishment of Aero-Engine State Variable Model Based on Linear Fitting Method

Aeroelasticity Numerical Analysis Via Volterra Series Approach

An Aerodynamics Calculation Method of a Flapping Wing Flying Robot Based on State-Space Airloads Theory

A New Interface Mapping and Marching Method for Aeroelasticity

Revisit of the Variable Stiffness Method for Aeroelastic Computations With/without Thermal Effects Based on Computational Fluid Dynamics

Comparative evaluation of unsteady aerodynamics modeling approaches at high angle of attack

Modeling of Aeroengine Hydro-Mechanical Controller and Analyzing of the Control System Performance

Efficient Nonlinear Reduced-Order Model for Computational Fluid Dynamics-Based Aeroelastic Analysis

Efficient Aeroelastic Reduced Order Model with Global Structural Modifications

Parametric Aeroelastic Modeling and Flutter Analysis for a Folding Wing

A New Method for Modeling of Fully Flexible Aircrafts

Numerical Simulation of Aeroelasticity Basing on Indentification Technology of Unsteady Aerodynamic Loads

A New Practical Computational Aeroelastic Method

A Method for Static Aeroelastic Analysis Based on the High-Order Panel Method and Modal Method

Identification of Reduced-Order Model for an Aeroelastic System from Flutter Test Data

Experimental and Numerical Investigations to the Aeroelastic Response of Flexible Thin Airfoil