Abstract:This paper compares several approaches to model the unsteady and nonlinear longitudinal aerodynamics of a generic unmanned combat air vehicle configuration based on computational fluid dynamics (CFD). Three different reduced-order models (ROMs) are implemented through unsteady simulations to predict the evolution of forces and moments during prescribed trajectories carried out at [Formula: see text]. The first model investigates a linear quasi-steady model based on a first-order Taylor series expansion of the aerodynamic coefficients. The second one picks up the mathematical formulation of the first model but adds a dynamic coefficient in order to take into account the unsteady effect of rotation rate variations. Finally, the third model is built on indicial functions computed from positive step changes in the angle of attack or pitch rate. The unknown parameters of the first two models and the unknown indicial functions of the third one are obtained, respectively, from the study of forced oscillations and step motions. These prescribed trajectories are performed using unsteady Reynolds-averaged Navier–Stokes simulations coupled with a grid displacement tool. Two different methods are tested and compared to carry out the CFD mesh motions: an overset method and a full moving grid (FMG) method. The indicial functions obtained using the FMG method give results equivalent to those found in the literature in half the time of the overset method. To reduce the computational costs to set up the ROMs, the FMG method is preferred to the overset method. ROMs are then applied, and their predictions are compared with CFD simulations for prescribed trajectories with different angular rates and angles of attack. A study of instantaneous and overall accuracy associated with the implementation cost of the ROMs has allowed to show their strengths and their weaknesses. Similar results are observed at low angles of attack for the ROMs studied, while a major modeling advantage of the indicial method has been identified for higher angles of attack in the nonlinear domain.

Model simplification methods for a reduced order system of flexible aircraft

Control-Oriented Modeling for Flexible Aircraft

Data-Driven Reduced-Order Aeroelastic Modeling of Highly Flexible Aircraft by Parametric Dynamic Mode Decomposition

MODELLING FRAMEWORK FOR FLIGHT DYNAMICS OF FLEXIBLE AIRCRAFT

A Novel Method for Constructing a Dynamics Model with the Flexible Characteristics

A Study on the Order Reduction of Vehicle Active Suspension Controller by Using Minimum Information Loss Method

Multibody Dynamic Approach of Flight Dynamics and Nonlinear Aeroelasticity of Flexible Aircraft

Model Reduction Using the Balanced Truncation Method and the Padé Approximation Method

The balanced mode decomposition algorithm for data-driven LPV low-order models of aeroservoelastic systems

Interpolation-Based Modeling Methodology for Efficient Aeroelastic Control of a Folding Wing

Multiple partitioning of flight data for manoeuvrable aircraft aerodynamic modeling and parameter estimation

Model order reduction of deep structured state-space models: A system-theoretic approach

Versatile Absolute Nodal Coordinate Formulation Model for Dynamic Folding Wing Deployment and Flutter Analyses

A novel unsteady aerodynamic Reduced-Order Modeling method for transonic aeroelastic optimization

Mathematical model of an aircraft electromechanical actuator with flex coupling

Assessment of low-altitude atmospheric turbulence models for aircraft aeroelasticity

Development of a Flight Mechanics Simulation Computer based on a Flexible Aircraft Model for a Regional Aircraft

Mathematical Modeling and Stability Analysis of Tiltrotor Aircraft

Aeroelastic Analysis of Transonic Flutter with CFD-Based Reduced-Order Model

Reduced-order modelling of floating offshore wind turbine: Aero-hydro-elastic stability analysis

Accuracy and Computational Cost Comparison of Numerical Flight Dynamics Reduced-Order Models