Abstract:The beam current transformer (CT) is an important part of the beam diagnostics system as a kind of nondestructive intensity measurement. The beam CT has the strong dependence of the sensitivity and time constant on the time structure of the beam. To measure the macropulse beam intensity with 5-10μs length and 238 MHz micro pulse repetition rate in the IR-FEL facility [1]. It is necessary to find a suitable material as the CT core which can meet the measure requirement of the beam current. In this paper, we figured out the key factor of the suitable material to be the CT core and three different magnetic materials were tested to find out that the laminated Febased nanocrystalline alloy core owned the best performance. Then, we designed the mechanical structure and improved the test device. The finished products have passed the acceptance test. INTRODUCTION The Infrared Free Electron Laser (IR-FEL) facility is currently under construction, which provides electron energy from 15 to 60 MeV, beam bunch with a macropulse length of 5-10 μs and a general micro-pulse repetition rate of 238 MHz. The beam current will be a first check concerns in the future daily operation. So it is important to develop a reliable beam current transformer which can meet the requirement to measure intensity and time structure of the bunch. The CT is non-intercepting, whose basic principle is the detection of the magnetic field carried by the beam. In the beam detection positon of the vacuum chamber, there will be a ceramic slit, and an outer ring with high magnetic permeability. Then an N-turn coil on the magnetic ring will pick up the electricity signal. A shielding box will stop the wall current to make sure that only the beam current pass through the beam current transformer. Figure 1 shows the schematic of the beam current transformer. The inductance of the magnetic ring is determined by

A New Wide-Band Beam Current Monitor with Active-Passive Circuit

An Active-Passive Beam Current Transformer

Interferometric Fiber-Optic Current Sensor

A Differential Compensated Air Coil Current Sensor for Switching Current Measurement of Power Devices.

A Non-Contact Broad Bandwidth Current Sensor

The Study of New Signal Processing Technique in Photon Beam Position Monitors

Measurement System Using Hybrid Optical Current Transducer for Small Pulse Current Signal

A Wideband Current Transducer Based on an Array of Magnetic Field Sensors for Rectangular Busbar Current Measurement

A Wide-Bandwidth Inexpensive Current Sensor Based on the Signal Fusion of Tunneling Magnetoresistance and a Current Transformer

Self-integrating Current Sensor for Fast Pulsed Current Monitor in Transmission Line.

High Bandwidth Measurement Of Partial Discharge Current Pulses Based On The Optimized Needle-Plate Electrode System

Development on the Zero-Flex Type Current Sensor

The New Beam Current Transformer for IR-FEL Facility at NSRL *

Design of Current Transformer for <italic>in Situ</italic> Current Measurement of Discrete SiC Power Devices

Electronic Current Transformer Based on Low-power Current Transformer

A Review of Megahertz Current Sensors for Megahertz Power Converters

Extended Wide-Bandwidth Rogowski Current Sensor With PCB Coil and Electronic Characteristic Shaper

A Compact DC-200MHz Hybrid Current Measurement Approach for Fast Switching Power Semiconductor Modules

Bunch-by-bunch beam current monitor for HLS

Development of a Wideband TMR Current Sensor for Partial Discharge Monitoring

Design and test of a compact beam current monitor based on a passive RF cavity for a proton therapy linear accelerator