Abstract:This article presents a proposal to describe the pressure changes in the combustion chamber of an engine as a function of the angle of rotation of the crankshaft, taking into account changes in rotational speed resulting from acceleration. The aim of the proposed model is to determine variable piston forces in simulation studies of torsional vibrations of a crankshaft with a vibration damper during the acceleration process. Its essence is the use of a Fourier series as a continuous function to describe pressure changes in one cycle of work. Such a solution is required due to the variable integration step during the simulation. It was proposed to determine the series coefficients on the basis of a Fourier transform of the averaged waveform of a discreet open indicator diagram, calculated for the registration of successive cycles. Recording of the indicative pressure waveforms and shaft angle sensor signals was carried out during tests on the chassis dynamometer. An analysis of the influence of the adopted number of series coefficients on the representation of signal energy was carried out. The model can also take into account the phenomenon of work cycle uniqueness by introducing random changes in the coefficients with magnitudes set on the basis of determined standard deviations for each coefficient of the series. An indispensable supplement to the model is a description of changes in the engine rotational speed, used as a control signal for the PID controller in the simulation of the load performed by the dynamometer. The accuracy of determining the instantaneous rotational speed was analyzed on the basis of signals from the crankshaft position angle sensor and the piston top dead center (TDC) sensor. Limitations resulting from the parameters of digital signal recording were defined.

The P-Ω Based Instantaneous Dynamic Model for Engine Governor

A transient dynamic model for HEV engine and its implementation for fuzzy-PID governor

Identification of Turbine Engine Dynamics with the Governor in the Loop

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Speed Governor for Gasoline Generator Based on Quasi Sliding Mode Control

Modeling the Influence of Engine Dynamics on Its Indicator Diagram

Research on integrate robust control Method for High-Power Variable-Speed Governor of Diesel Engine by loop-shaping theory

Optimal Design of Discrete-Time Fractional-Order PID Controller for Idle Speed Control of an IC Engine

Design of Idle Speed Controller for an SI Engine Based on Incremental Digital PID

Optimization of Governor Parameters to Prevent Frequency Oscillations in Power Systems

Model based moving horizon optimization control of automotive engine speed

PID Control of Engine Speed Tuning for Hybrid Electric Vehicle

Design of an SI Engine Cold Start Controller based on Dynamic Coupling Analysis

Idle speed control with low-complexity offset-free explicit model predictive control in presence of system delay

A Control-Oriented Engine Torque Online Estimation Approach for Gasoline Engines Based on In-Cycle Crankshaft Speed Dynamics

Research on Engine Characteristics Based on Cyclic Mode Variable Displacement Control

Constant Speed Control of Four-stroke Micro Internal Combustion Swing Engine

Adaptive Speed Control Based On Disturbance Compensation For Engine-Dynamometer System

Dynamic Simulation of a Two-Stroke Spark Ignition Free-Piston Engine Generator

A Comprehensive Decoupling Control Method for Gasoline HCCI Combustion

Combustion stability control of a single-piston free piston engine generator