Abstract:Past research has shown substantial reductions in the oxides of nitrogen (NOx) concentrations by using 10%-25% exhaust gas recirculation (EGR) in spark ignition (SI) engines (see Dudek and Sain, 1989). However, under high EGR levels, the engine exhibits strong cyclic dispersion in heat release which may lead to instability and unsatisfactory performance preventing commercial engines to operate with high EGR levels. A neural network (NN)-based output feedback controller is developed to reduce cyclic variation in the heat release under high levels of EGR even when the engine dynamics are unknown by using fuel as the control input. A separate control loop was designed for controlling EGR levels. The stability analysis of the closed-loop system is given and the boundedness of the control input is demonstrated by relaxing separation principle, persistency of excitation condition, certainty equivalence principle, and linear in the unknown parameter assumptions. Online training is used for the adaptive NN and no offline training phase is needed. This online learning feature and model-free approach is used to demonstrate the applicability of the controller on a different engine with minimal effort. Simulation results demonstrate that the cyclic dispersion is reduced significantly using the proposed controller when implemented on an engine model that has been validated experimentally. For a single cylinder research engine fitted with a modern four-valve head (Ricardo engine), experimental results at 15% EGR indicate that cyclic dispersion was reduced 33% by the controller, an improvement of fuel efficiency by 2%, and a 90% drop in NOx from stoichiometric operation without EGR was observed. Moreover, unburned hydrocarbons (uHC) drop by 6% due to NN control as compared to the uncontrolled scenario due to the drop in cyclic dispersion. Similar performance was observed with the controller on a different engine.

Design of an SI Engine Cold Start Controller based on Dynamic Coupling Analysis

Adaptive and Learning Control for SI Engine Model With Uncertainties

Engine Control Design Using Globally Linearizing Control and Sliding Mode

Nonlinear control approaches for SI engine model with uncertainties

An Integrated Controller Design for a Small Aero-Engine

A Comprehensive Decoupling Control Method for Gasoline HCCI Combustion

An Economic Nonlinear Model Predictive Control Strategy for SI Engines: Model-Based Design and Real-Time Experimental Validation

Discrete Adaptive Second Order Sliding Mode Controller Design with Application to Automotive Control Systems with Model Uncertainties

Design of Variable Weight SDRE Control Algorithm for Civil Aeroengine Transition State

Real-time Control Oriented HCCI Engine Cycle-to-cycle Dynamic Modelling

Closed-Loop Diesel Combustion Control Leveraging Ignition Assist

The Nonlinear Single Controller Of Dgen380 Aero Engine Design

An Advanced High Dimensional Model Representation Approach for Internal Combustion Engine Modeling and Optimization

Computational Intelligence Nonmodel-Based Calibration Approach for Internal Combustion Engines

Development of a Model-Based Coordinated Air-Fuel Controller for a 3.0 dm3 Diesel Engine and Its Assessment through Model-in-the-Loop

Minimization of Torque Deviation of Cylinder Deactivation Engine through 48V Mild-Hybrid Starter-Generator Control

Development of a Fast, Robust Numerical Tool for the Design, Optimization, and Control of IC Engines

Sensor selection and controller design method with application to turbocharged stoichiometric spark-ignited engine controls with low pressure EGR

Realization and Control of SI/HCCI Mode Switch on a GDI Engine

A Real-Time Control Oriented HCCI Combustion Model in 4-Stroke HCCI/SI GDI Engine and Model-Based Fast Calibration Development

Neural network controller development and implementation for spark ignition engines with high EGR levels