Abstract:SO2 emissions from coal-fired boilers are air pollutants and a source of acid rain, causing extensive environmental pollution. Limestone (CaCO3) is a Ca-based sorbent which is injected into circulating fluidized bed (CFB) boilers, where it combines with SO2 to produce calcium sulfate (CaSO4). As a result, SO2 emissions from a power plant are reduced. In this study, CaCO3 addition was proposed and the desulfurization efficiency improved. The direct desulfurization reaction is dominant in a commercial CFB boiler due to the high CO2 partial pressure, but CaO is formed at a fast reaction rate by calcination in the high temperature or in the low CO2 partial pressure region. When CaO remains in the loop seal, it is exposed to a high CO2 partial pressure condition moving through the recirculation section for an extended period and re-injected into the furnace as recarbonated CaCO3. To analyze the direct desulfurization reaction kinetics, a shrink core model in which the reaction proceeds inside the particle was adopted. Surface observations through FE-SEM of CaSO4 produced by the 180 minute long desulfurization experiment using TGA suggest that the CaSO4 crystal growth rate increased after the pre-treatment (recarbonation) of limestone. Recarbonation lowered the limestone crystallinity, causing a faster reaction. The CaCO3 recarbonation increased the Ca utilization by more than 20% when the direct desulfurization reaction occurred. The TGA experiments show that recarbonation contributes to CaSO4 conversion. Increasing the desulfurization efficiency using recarbonation can reduce the fixed investment and operating costs of oxy-fuel CFB plants because only desulfurization in the furnace is able to meet SO2 emission regulations or lower the flue gas desulfurization (FGD) dependence. Accordingly, the desulfurization conversions of recarbonated CaCO3 and limestone were compared in this study. Morphological changes in the limestone were also evaluated using XRD, FE-SEM, and other analysis methods.

Wet flue gas desulfurization by organic acid-enhanced coarse limestone

New technology of wet FGD process using granular limestone and organic acid additives in bubbling reactor

New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives

Feasibility Study Of New Limestone Flue Gas Desulfurization Process

Enhancement of citric acid on low-grade limestone wet desulfurization performance coupled with spray and partial bubble technology

Experimental Study of Desulfurization Process with Limestone Slurry Enhanced by Hexanedioic Acid

Limestone Dissolution with Organic Acid Additives in Wet Flue Gas Desulfurization

Chemical Absorption of SO2 by Using Ethylene Diamine/Phosphoric Acid Solution

Experimental Study on Additive Enhanced Limestone Wet Flue Gas Desulfurization

Experimental study on SO2 absorption rate enhanced by additive in limestone-gypsum WFGD process

Absorption of SO2 from Flue Gas by Aqueous Fulvic Acid Solution

Experimental Study of Limestone/Gypsum-based Wet Process Flue Gas Desulfuration

[Sodium-Enhanced Limestone Wet FGD in Rotating-Stream Tray Scrubber].

Insights into the Desulfurization Mechanism of Low-Grade Limestone As Absorbent Induced by Particle Size

Application and experimental investigation of compound additive enhanced wet flue gas desulfurization process

Studies on flue gas desulfurization by chemical absorption using an ethylenediamine-phosphoric acid solution

Experiment of wet FGD process with waste marble]

Study on a Novel Semidry Flue Gas Desulfurization with Multifluid Alkaline Spray Generator

Analysis and Optimization of Chemical Processing Parameters for Wet Flue Gas Desulphurization System

A comparative evaluation of recarbonated CaCO3 derived from limestone under oxy-fuel circulating fluidized bed conditions

Insights into Catalytic Effect of Fe3+ and MnO4- on SO2 Absorption for Phosphoric Acid Production by Phosphate Rock Slurry