Abstract:Silicon Photomultiplier (SiPM) has been demonstrated to be a high performance PET sensor as alternative to conventional photomutiplier tubes. The aim of this work is to develop a PET detector module with compact SiPM device which consists of 3x3 SiPM arrays (4x4 pixels each array, 3.17x3.17 mm(2) each pixel). A compact design of readout electronics is proposed based on discretized position-sensitive readout circuits (DPC) and time based readout ASIC. The function of the ASIC is to convert all signals' energy and timing information into digital timing pulses which can be processed by back-end simple Time-Digital-Convertor (TDC). So we get highly integrated electronics because the traditional Analog-Digital-Convertor (ADC) and Constant-Fraction-Discriminator (CFD) are replaced. A temperature-dependent gain control module including a microcontroller, a DAC and a DC-DC converter is designed to stabilize the gain of SiPM arrays against the variance of ambient temperature, which is based on the temperature sensor and serial identification chip intergrated in the SiPM array package. An preliminary experimental study was conducted, in which one SiPM array was coupled to a 6x6 LYSO crystal block. With a resistor charge-division chain readout circuit, a flood histogram map was acquired in which the crystals were clearly identifiable. With the correction of the gain control module, the maximum gain drift of SiPM decreases from 79.67% to 11.03% as the temperature varies from 27 degrees C to 50 degrees C. The result indicates that the developed gain control module can contribute to improving the stability of SiPM based PET detector. Through some basic tests, the ASIC has demonstrated good performances of linearity and uniformity. We conclude that the proposed design is feasible for developing a compact SiPM PET detector module.

Optimized Design of High Sensitivity Micromechanical Photon Detectors

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

Optical Design and Analysis of a High Resolution MOEMS Accelerometer Based on Diffraction Grating

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

High-performance Flexible Waveguide-Integrated Photodetectors

Strain-Engineering-Driven Photomechanical–Photoelectric Coupled Flexible Photodetector Based on Hexagonal Silicon Nanowire Films

Design of Micromechanical Thermopile Infrared Detector Compatible with CMOS Process

Optimal design of optomechanical uncooled infrared focal plane array with integrated metalens

High-sensitivity Optical Sensors Based on Cascaded Reflective MZIs and Microring Resonators

Design and Optimization of Laminated Piezoresistive Microcantilever Sensors

Monte Carlo Modeling and Design of Photon Energy Attenuation Layers for >10× Quantum Yield Enhancement in Si-Based Hard X-ray Detectors

MEMS Based Optomechanical Infrared Imaging

Design of Metasurface-Based Photodetector with High-Quality Factor

Structure design and test of MEMS thermocouple infrared detector

Monte Carlo Modeling and Design of Photon Energy Attenuation Layers (PALs) for 10-30x Quantum Yield Enhancement in Si-based Hard X-ray Detectors

Study on a High Performance MEMS Infrared Thermopile Detector

Design and Realization of New Optical Sequential Readout for Micro-cantilever Array

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

Self‐assembled Dielectric Microsphere As Light Concentrators for Ultrathin‐silicon‐based Photodetectors with Broadband Enhancement