Abstract:This paper studies the migration and deposition of suspended particles in porous media. This problem results from the fact that during the operation of a groundwater source heat pump, the recharging process will contribute to the impairment of soil permeability. A coupling lattice Boltzmann method, discrete element method and immersed moving boundary method were used to investigate the migration of particles in porous media. The DKT (Drifting, Kissing, Tumbling) phenomena were employed to validate our program. The coupled effects of concentration, flow rate and pH on the clogging mechanism of the porous media were analyzed. Results show that, due to the repulsive barrier between the particles and porous media, there is a critical velocity. At a low flow rate, the deposition ratio increases with the increase in velocity. Beyond the critical velocity, the deposition ratio decreases when the velocity increases due to higher shear force. Permeability impairment increases with the increase in concentration, especially in the low flow rate condition. Changes in pH mainly affect the repulsive barrier. For a low flow rate, the decrease in repulsive barrier greatly promotes the deposition of particles. Under the condition of favorable deposition, the increase in flow rate reduces the deposition phenomenon. Under the condition of unfavorable deposition, the lower flow rate condition has a lower deposition ratio. The process of particle deposition and the dynamic motion after deposition were observed such as particles gliding over the surface. Accumulated particles in the downstream form bridges and hinder fluid flow. At a high flow rate, strong shear force is more capable of destroying bridges and recovering permeability. Adsorbed particles glide on the surface of the grain and deposit in the downstream. This paper aims to help understanding of the micro-events of particle deposition and the clogging process.

Flow Pipe's Plug-Removing of Benthic Meiobenthos Separating Device

Flow Pattern Identification Method of Gas-Liquid Two-Phase Flow in Ductule Based on New C4 D

Experiment Research on Physical Clogging Mechanism in the Porous Media and Its Impact on Permeability

Optimized Flow Pipe's Parameters for Benthic Meiobenthos Separation System

Experimental Investigation on Vertical Plug Formation of Coarse Particles by a Non-Mechanical Feeder

A New Method for Velocity Measurement of Gas-Liquid Two-Phase Flow Based on C~4D Technique

Bubbling Behaviors Induced by Gas-Liquid Mixture Permeating Through A Porous Medium

Investigation on Vertical Plug Formation of Coarse Particles in a Non-Mechanical Feeder by CFD-DEM Coupling Method

Experimental Study on Plug Formation Characteristics of a Novel Draft Tube Type Feeder for Vertical Pneumatic Conveying of Coarse Particles

Particle shape and clogging in fluid-driven flow: A coupled CFD-DEM study

3D CFD simulation of the liquid flow in a rotating packed bed with structured wire mesh packing

Experimental Investigation on Mitigation of Severe Slugging in Pipeline-Riser System by Quasi-Plane Helical Pipe Device

Modeling of Particle Migration in Piping Based on an Improved Discrete Element Method

Study of the hydraulic transport of non-spherical particles in a pipeline based on the CFD-DEM

A many-body dissipative particle dynamics simulation of flow performance in capillary channel

Flow analysis in right-angled pipes with different geometric shapes and parameters for sludge discharge in slime shield machines measured using a CFD-DEM method

Investigation of Flow Characteristics of Superfluid Helium Porous Plug Phase Separator

Clogging and Unclogging of Fine Particles in Porous Media: Micromechanical Insights From an Analog Pore System

Study on the Behavior and State of Viscous Fractured Leakage Bridging and Plugging Slurry during the Pump-In and Pressurization Process

A Bionic Degassing Device Inspired by Gills: Application on Underwater Oil and Gas Detection

Pore-Scale Simulations of Particles Migration and Deposition in Porous Media Using LBM-DEM Coupling Method