Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Large Eddy Simulation of Temperature Field and Velocity Field in Standard Fire Test Room

Large Eddy Simulation of Fire Spread Behavior in an Under-Ventilated Room

Application of Large Eddy Simulation to Smoke Movement

Validation And Evaluation Of Large Eddy Simulation Based Field-Zone Model For Smoke Movement In Building Fires

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Large Eddy Simulation of Smoke Movement with a Water Spray

Detached-eddy simulation k-ε turbulence model and its application in fire simulations

Large Eddy Simulation of Flow Field in Vector Flow Clean-Room

Studies on a Swirling Heptane Spray Flame by Large-Eddy Simulation

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Large Eddy Simulation in Turbulent Combustion Research

Modeling Fire-Induced Smoke Spread and Carbon Monoxide Transportation in a Long Channel: Fire Dynamics Simulator Comparisons with Measured Data

Estimation and research of the temperature field models of large space spherical mesh shell structures under localized fire

Numerical Investigation of Swirl-Stabilized Pulverized Coal Flames in Air and Oxy-Fuel Atmospheres by Means of Large Eddy Simulation Coupled with Tabulated Chemistry

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Two Typical Phenomena from the Numerical Simulation of Fire and Smoke Transport in A Gymnasium Fire

Investigation on Smoke Flow in Stairwells Induced by an Adjacent Compartment Fire in High Rise Buildings

Large eddy simulation of compartment fire with solid combustibles

Numerical Simulation Analysis on Temperature Field for Large-space Structures under Fire