Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Large Eddy Simulation of Fire Spread Behavior in an Under-Ventilated Room

Large Eddy Simulation of Temperature Field and Velocity Field in Standard Fire Test Room

Flame behavior and fire-induced flow field characteristic in building corridor fire with longitudinal partition

Application of Large Eddy Simulation to Smoke Movement

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Full-scale Experimental and Numerical Study of Smoke Spread and Temperature Distribution in a Room-Corridor Structure Building

A Numerical Study on the Smoke Dispersion and Temperature Distribution of a Ship Engine Room Fire Based on OpenFOAM

Large Eddy Simulation of Smoke Movement with a Water Spray

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Large eddy simulation of compartment fire with solid combustibles

Computational Simulation of Smoke Temperature Diffusion in High-rise Buildings Fires

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Investigation on Smoke Flow in Stairwells Induced by an Adjacent Compartment Fire in High Rise Buildings

An Investigation on Spill Plume Temperature of Large Space Building Fires

Validation And Evaluation Of Large Eddy Simulation Based Field-Zone Model For Smoke Movement In Building Fires

Simulation and Analyses of Contact Smoke Detection in Large Space Fire

Numerical Simulation of Smoke Control in Underground Space

Experimental Study on the Transitional Behavior of the Room Fire under Sub-Atmospheric Pressures

Temperature Distribution of Room Fire and Window Spill Flame with a Slope Constrain