Modification of Hydrotalcite Loading Tannic Acid with Organic Silane and Application in Anticorrosive Epoxy Coating
Bui Minh Quy,Nguyen Thuy Chinh,Nguyen Thi Kim Anh,Vu Thi Tuyet,Nguyen Xuan Thai,Vu Quoc Trung,Ngo Thi Cam Quyen,Nguyen Ngoc Tan,Thai Hoang
DOI: https://doi.org/10.1002/open.202400120
ChemistryOpen
Abstract:Metal corrosion is a challenge for the world with heavy impacts on the economy. Study on the development of effectiveness anticorrosion additives is a promising strategery for the protection industry. This research focuses on the modification of hydrotalcite Mg-Al (HT) loading tannic acid (TA) with 3-(trimethoxy silyl) propyl methacrylate organo-silane (TMSPM) for applicating as an anti-corrosion additive for epoxy coating on the steel substrate. The suitable ratio of HT and modifiers was investigated and the suitable content of modified HT in epoxy matrix was found based on mechanical properties of the epoxy-based coating. The characteristics of modified HT were assessed through infrared (IR) spectroscopy, X-ray diffraction pattern (XRD), scanning electron microscopy (SEM), thermal gravimetry analysis (TGA), water contact angle (WCA), dynamic light scattering (DLS). Detailly, HT-TA3-S3 shows good stability in distilled water when HT/TA was modified with TMSPM which makes Zeta potential decreases significantly. Besides, SEM analysis presented HT-TA-S has a cylindrical shape about of 500 nm. Moreover, the crystallite size of HT/TA after being modified by TMSPM decreases sharply. All of these prove successfully synthesize HT loading TA with modified TMSPM. Water contact angle (WCA) decreases in case of loading TA and increases in case of modifying with TMSPM (WCA changed from HT (116.3°) to HT-TA (102.4°) and HT-TA-S (120.1°) which indicates the increased hydrophobicity of the sample. The obtained results showed HT/TA was modified successfully with TMSPM. The modification affected the size distribution and surface properties of HT nanoparticles while it did not impact on the crystal structure of HT. After incorporating modified HT/TA into the epoxy coating, the adhesion of coating to steel substrate was improved significantly. Consequently, the adhesion of epoxy/3 wt. % modified HT/TA coating was increased 3 times as compared to epoxy neat (from 0.76 MPa to 2.77 MPa). In addition, the relative hardness and gloss retention of epoxy/3 wt. % modified HT/TA coating reached the maximum values as compared to the others. Owing to salt spraying results, the epoxy/3 wt. % modified HT/TA exhibited an excellent anticorrosion ability for the steel substrate. All the above results show the potential of HT nanoparticles loading TA modified with TMSPM as anticorrosive additives for protective coatings on steel substrates.