Abstract:Amorphous hydrous ruthenium oxide/active carbon (RuO2. xH(2)O/C) powders were prepared by a simple procedure based on the sol-gel process. The precursor was obtained by mixing an aqueous solution of RuCl3 and active carbon powders at pH 7. When annealing the precursor at 150 degreesC for 7-9.5 h, the RuO2. xH(2)O/C powders obtained had the highest specific capacitance. Transmission electron microscopy photographs showed that the RuO2. xH(2)O primary particles were about 10-15 nm diam. They adhered to form large porous secondary particles. A modeling capacitor was made with electrodes comprised of RuO2. xH(2)O/C powder and 30% H2SO4 electrolyte. At 10-20 wt % ruthenium in the electrodes, the specific capacitance remained almost unchanged at 243 F/g, which included both the electric double-layer capacitance associated with the high surface area of active carbon and redox capacitance associated with ruthenium oxide. About 52% of the RuO2 in the RuO2. xH(2)O/C powders was utilized. More than 50% of the capacitance in the electrode with 12.1% ruthenium was due to the formation of the double layer, but for the electrode with 21.1% ruthenium, the capacitance attributed to the double layer dropped to 16.8% of the total capacitance. When the electrodes contained ruthenium from 35 wt % to pure RuO2. xH(2)O, the specific capacitance increased from 350 to 715 F/g. The specific capacitance was proportional to the mass of the ruthenium in the electrodes. This enabled the specific capacitance to be controlled by changing the mass ratio of RuCl3 to active carbon in the preparation. Physical properties of the material and electrochemical characteristics of electrodes are also reported along with the capacitor performance. (C) 2001 The Electrochemical Society.

Nano ruthenium oxide/carbon nanotubes composite electrode material for electrochemical capacitors

Carbon Nanotube Capacitor Materials Loaded with Different Amounts of Ruthenium Oxide

Pseudo-capacitance of ruthenium oxide/carbon black composites for electrochemical capacitors

Electrochemical Behavior Of Amorphous Hydrous Ruthenium Oxide/Active Carbon Composite Electrodes For Super-Capacitor

Preparation And Electrochemistry Of Hydrous Ruthenium Oxide/Active Carbon Electrode Materials For Supercapacitor

Hydrous Ruthenium Oxide with High Rate Pseudo-Capacitance Prepared by a New Sol-Gel Process

Supercapacitive Properties Of Hydrous Ruthenium Oxide/Multi-Walled Carbon Nanotubes Nanocomposite

Activated Carbon Based Ruthenium Oxide Materials For Supercapacitor

Ultra-Fine Ruthenium Oxide Quantum Dots/Reduced Graphene Oxide Composite as Electrodes for High-Performance Supercapacitors

Synthesis of Ru/carbon nanocomposites by polyol process for electrochemical supercapacitor electrodes

Electrochemical Performance of RuO2/Active Carbon Composite Electrodes

Preparation and Electrochemical Capacitance of RuO2/TiO2 Nanotubes Composites

Electrochemical Performance Of Combined Ni(Oh)(2)/Carbon Nanotubes(Cnts) Composite-Activated Carbon Supercapacitor

Hydrothermal Synthesis of CuO/RuO2/MWCNT Nanocomposites with Morphological Variants for High Efficient Supercapacitors

Development of Supercapacitors Based on Carbon Nanotubes

Electrochemical Capacitor with the Electrode of Nickel Hydroxide/Carbon Nanotube Composite

Nanofeather ruthenium nitride electrodes for electrochemical capacitors

Hydrous–ruthenium–oxide thin film electrodes prepared by cathodic electrodeposition for supercapacitors

Conformal Coatings of NiCo2O4 Nanoparticles and Nanosheets on Carbon Nanotubes for Supercapacitor Electrodes

A Cr2O3/MWCNTs composite as a superior electrode material for supercapacitor

Graphene induced crystallinity and hydrous state variations of ruthenium oxide electrodes for superior energy storage performance