Abstract:We present an experimental investigation aimed at understanding the effects of surface roughness on the time-mean drag coefficient ( ) of finite-span cylinders ( , ) freely rolling without slip on an inclined plane. While lubrication theory predicts an infinite drag force for ideally smooth cylinders in contact with a smooth surface, experiments yield finite drag coefficients. We propose that surface roughness introduces an effective gap ( ) resulting in a finite drag force while allowing physical contact between the cylinder and the plane. This study combines measurements of surface roughness for both the cylinder and the plane panel to determine a total relative roughness ( ) that can effectively describe at the point of contact. It is observed that the measured increases as decreases, aligning with predictions of lubrication theory. Furthermore, the measured approximately matches combined analytical and numerical predictions for a smooth cylinder and plane when the imposed gap is approximately equal to the mean peak roughness ( ) for rough cylinders, and one standard deviation peak roughness ( ) for relatively smooth cylinders. As the time-mean Reynolds number ( ) increases, the influence of surface roughness on decreases, indicating that wake drag becomes dominant at higher . The cylinder aspect ratio ( ) is found to have only a minor effect on . Flow visualisations are also conducted to identify critical flow transitions and these are compared with visualisations previously obtained numerically. Variations in have little effect on the cylinder wake. Instead, was observed to have a more pronounced effect on the flow structures observed. The Strouhal number ( ) associated with the cylinder wake shedding was observed to increase with , while demonstrating little dependence on .

Investigation on effect of surface roughness pattern to drag force reduction using rotary rheometer

Study of the Effect of Transverse and Longitudinal Surface Patterns on Drag-Reduction in Shear-Thinning Fluid

Computational Studies On Drag Reduction Effect By Surface Grooves

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Investigation on the Effect of Transverse Grooves on Friction Force

Analysis of the Drag Reduction Performance and Rheological Properties of Drag-Reducing Additives

Interactive experimental study on microgroove structure and drag‐reducing additives in rotating disk apparatus

Numerical Analysis on the Effect of Transverse Surface Roughness in Non-Newtonian Fluid Lubrication

RESEARCH ON DRAG REDUCTION CHARACTERISTICS OF UNDERWATER VEHICLE FORE REGION WITH SHORT GROOVE STRUCTURES

Application and Optimization of Drag Reduction Characteristics on the Flow Around a Partial Grooved Cylinder by Using the Response Surface Method

Mechanism of Flow Drag Reduction on Non-Smooth Surface

Study on drag reduction mechanism of rotating disk with micro-grooves

Study on Drag Reduction of Hydrophobic Surface

Experimental Study on the Drag Reduction Effect of a Rotating Superhydrophobic Surface in Micro Gap Flow Field

Characterization of drag reduction performance over rotating microgrooves with different cross-sections

Flow structures and wall parameters on rotating riblet disks and their effects on drag reduction

Effects of surface roughness on the drag coefficient of finite-span cylinders freely rolling on an inclined plane

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Effect of surface roughness on sliding friction in lubricated contacts-reciprocal experiment study

Drag Reduction by Microvortexes in Transverse Microgrooves

Investigation of the resistance characteristics of the transverse groove for laminar flows