Abstract:Relative pose detection is a key technology in large component automatic docking systems. In this paper, a measurement system has been developed to detect the relative pose of large aircraft components with draw-wire displacement sensors, while an analytical calculation method has been proposed to determine the docking pose of large aircraft components. This method establishes a measurement model for the docking pose of large components and separates the position and orientation solutions based on the distances between seven sets of measurement points measured by the draw-wire displacement sensors. First, the principle of three-dimensional rendezvous positioning is refined to ascertain the relative position of the components. Then, by analyzing the properties of the rotation matrix and the coupling relationship between the position and orientation variables of the movable component, 15 compatible equations containing only two variables with a maximum degree of four are obtained. Based on this set of equations, a unique solution for the rotation matrix was obtained through the variable substitution method, gradually eliminating higher-order terms. Finally, the correctness of the method is verified through numerical examples. Unlike typical parallel mechanism models, this model can directly obtain 15 compatible equations without the need for methods such as Gröbner bases. Moreover, compared to the measurement method using six draw-wire displacement sensors, a unique solution can be directly determined, solving the problem of multiple solution selection. This measurement method only requires measuring the distance between measurement points to solve the relative pose, with low equipment costs and less susceptibility to external environmental factors.

NONLINEAR PHYSICAL PARAMETER IDENTIFICATION OF THE DOCKING MECHANISM

PARAMETRIC IDENTIFICATION OF PARALLEL MANIPULATOR WITH REDUNDANCY DRIVEN BY PNEUMATIC MUSCLES

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

A Parameter Dimension Reduction-Based Estimation Approach to Enhance the Kinematic Accuracy of a Parallel Hardware-in-the-Loop Docking Simulator.

Parameter Identification of Hydraulic Manipulators Considering Physical Feasibility and Control Stability

Closed-Loop Dynamic Parameter Identification of Robot Manipulators Using Modified Fourier Series

Dynamics Parameter Identification of Articulated Robot

Construction of a Measurement System and Analytical Solution for Docking Pose of Large Aircraft Components Based on Draw-wire Displacement Sensors

A general and novel approach for parameter identification of 6-DOF parallel kinematic machines

An Inertial Parameter Identification Method of Eliminating System Damping Effect for a Six-Degree-of-freedom Parallel Manipulator

Terminal Force Soft Sensing of Hydraulic Manipulator Based on the Parameter Identification

Force and Moment Compensation Method Based on Three Degree-of-Freedom Stiffness-Damping Identification for Manipulator Docking Hardware-In-The-Loop Simulation System.

Identification of Dynamic Parameter of a 3DOF Parallel Manipulator With Actuation Redundancy

Inertial Parameter Identification for Closed-Loop Mechanisms: Adaptation of Linear Regression for Coordinate Partitioning

On Inertial Parameter Identification of Module Robots

A Novel LLSDPso Method for Nonlinear Dynamic Parameter Identification

A Method for Parameter Identification of Mechanical System Based on Differential Motion Equations

Two-step method for identifying physical parameters of systems with dead zone nonlinearity

Automatic identification of structural modal parameters based on density peaks clustering algorithm

Docking Dynamics Simulation of Spacecraft with Peripheral Docking Mechanism(Part:I)--Equation of Kinematics Constrained

Normal Contact Stiffness Identification-Based Force Compensation for a Hardware-in-the-loop Docking Simulator