Abstract:Miniaturized quartz tuning forks (QTFs) have been adopted as force sensors for non-contact atomic force microscopy (AFM). However, the coupled oscillation behaviors of the QTF prongs are not well understood, preventing quantitative measurement of the nanoscale tip-sample interaction forces. This article presents a lumped model that accurately delineates the coupled mechanical oscillations of QTF prongs, establishing rigorous relationships between experimental observables and tip-sample interaction forces. The first-order resonance spectra of a commercial QTF were fully characterized by correlating its piezoelectric response with the actual mechanical oscillation measured with a Fabry-Pérot interferometer. In order to uniquely determine the modeling parameters (i.e., the effective masses, spring constants, and damping constants), the experimental results were compared with the lumped model predictions while masses were added to one prong. The results reveal that the QTF's center of mass is highly damped, preventing the observation of a symmetric resonance mode. In addition, the mass loading experiment demonstrates that the mechanical oscillations of the QTF prongs are strongly coupled, accounting for 59% (84%) of the effective stiffness at the in-plane (out-of-plane), antisymmetric resonance mode. We believe that the obtained QTF characterization results will pave the way for quantitative measurements of non-contact interaction forces in QTF-based AFM platforms, significantly improving the precision and reliability of nanoscale force measurements.

Mechanism for Shear-force Between Tip and Sample in NSOM and TSM

The influence of humidity on the shear force between tip and sample in NSOM using piezoelectric fork

Dynamic Behavior of Tuning Fork Shear-Force Structures in a SNOM System

A novel ultrasonic resonance sample-tip distance regulation for near field optical microscopy and shear force microscopy

Research On The Sensing Performance Of The Tuning Fork-Probe As A Micro Interaction Sensor

A Novel Non-Optical Method of Tip-Sample Distance Regulation Based on Shear Force in Scanning Near-Field Optical Microscopy

Improvement and Application of Scanning Near Field Optical Microscope Based on A Piezoelectric Bimorph Shear Force Beam

Shear Force Detection Using Single-Tine Oscillating Tuning Fork for Scanning Near-Field Optical Microscopy

Sensing Performance Analysis on Quartz Tuning Fork-Probe at the High Order Vibration Mode for Multi-Frequency Scanning Probe Microscopy.

Experimental analysis of tip vibrations at higher eigenmodes of QPlus sensors for atomic force microscopy

Study of piezo-induced surface vibration in solids using atomic force probe

Active Bimorph-Based Tapping-Mode Distance Control for Scanning Near-Field Optical Microscopy of Biological Samples in Liquid

J0610104 Evaluation of Interatomic Force on the Tip of Probe by Using Microwave Atomic Force Microscope

Sub-terahertz scanning near-field optical microscope using a quartz tuning fork based probe

Improvement of Tapping-Mode Scanning Near-Field Optical Microscope

Nonlinearly torsional vibrations in acoustic friction force microscope.

The Observation of Interface Effects Presented on Micrometer-Scale Sphere Tips of Fiber Bragg Grating-Based Probes

Characterization of strongly coupled quartz tuning fork sensors for precision force measurement in atomic force microscopy

Ultrasonic resonance regulated near-field scanning optical microscope and laser induced near-field optical-force interaction

Investigation of Loading and Force Sensing Properties of a Probe-Type Microforce Sensor with Force-Distance Curves

Microstructured Cantilever Probe on Optical Fiber Tip for Microforce Sensor