Abstract:Friction stir welding (FSW), as a solid state joining technique, has emerged as an efficient method for manufacturing tailor-welded blanks to optimize weight or performance in the final component. As the basic design of lightweight frame structures in the automotive and aircraft industry is frequently based on tubular profiles, the joining strategies and forming technologies have to be developed accordingly. In the present study, FSW tube was produced by a novel processing sequence. The plastic deformation characteristics during hydroforming were experimentally and numerically investigated with two types of end condition. The hydroforming performance of the FSW tubes was mainly investigated by die-bulge forming with fixed ends, and the wrinkling behavior during hydroforming was analyzed by employing axial feed on the tube ends. It is found that hydroforming FSW tube is a new deal and does show a few peculiarities. The FSW tube exhibits a spiral weld and the basin-shaped nugget. Fine-grained structure is retained during tube forming. The thinning of the tube in axial direction shows M-shaped distribution during hydroforming. The severe thinning is observed at one quarter of the expansion zone from symmetry plane. In the hoop direction, the base material near the weld suffers severe thinning due to the high hoop and axial tensile stress. The thickness distribution greatly depends on the sequence of the contacting die and the variations of the curvature radius of the tube during hydroforming. Moreover, the weld shows an inhibitory effect for the generation of the wrinkles and decreases the number of the wrinkles as compared to the seamless tube during hydroforming. This effect is more obvious when the forming pressure is lower.

Stress and strain state of tube hydroforming and it's influence on destabilization

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Effect of Strain State on the Surface Roughening for Hydroforming of Aluminum Alloy Tube Based on Cross-Scale Numerical Modeling

Complex Stress-Strain Relations of Tubular Materials Studied with A Flexible Hydroforming System

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Plastic Deformation on Hydroforming of Aluminum Alloy Tube with Rectangular Sections

Further Assessment of the Plastic Instability of Thin-Walled Tubes in Double-Sided Hydro-Bulging Process with Verification Experiments

Experimental Verification of the Influence of Normal Stress on the Formability of Thin-Walled 5a02 Aluminum Alloy Tubes

Deformation Analysis of Double-Sided Tube Hydroforming in Square-Section Die

An Approach to Improve Thickness Uniformity Within Tailor-Welded Tube Hydroforming

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Study on Experimental Approaches of Forming Limit Curve for Tube Hydroforming

Predicting the forming limits in the tube hydroforming process by coupling the cyclic plasticity model with ductile fracture criteria

Experimental and Numerical Study on Hydroforming Characteristics of Friction Stir Welded Aluminum Alloy Tubes

Forming Limit Evaluation by Considering Through-Thickness Normal Stress: Theory and Modeling

Mechanical Conditions of Stiffened Tube during Hydro-assisted Forming

Practicality and Formability of Integrally Stiffened Tube Hydro-Assisted Forming

Study on Formability of Tube Hydroforming Through Elliptical Die Inserts

PRINCIPLE AND MECHANICS ANALYSIS FOR BIMETALLIC TUBE FORMED BY HYDRAULIC EXPANSION

Research on wrinkling behavior in tube hydroforming

Analysis of Transition Corner Formation in Hydroforming of Rectangular-Section Tube