Abstract:Wireless Power Transfer (WPT) brings convenience and safety in many applications and serves as a research hot spot in recently years. Magnetic resonant coupling is widely implemented in WPT applications such as mobile devices and electric vehicles where large distance, large power amount and high efficiency are the three key requirements in real application. However, there are always trade-offs between these requirements even in theory. Former literatures failed to illustrate the complete relationships between these requirements. Based on the phasor analysis, this paper illustrates the operating principle of the whole circuit, attains the equivalent circuit models of the system and derives the physical essence of frequency characteristics. Then Maximum Efficiency Conditions (MEC), which achieves the maximum efficiency without sacrificing the requirements for power transfer distance and power amount, is summarized. It should be noted that the highest efficiency is achieved at the natural frequency of the receiver, instead of any split frequencies of the coupled resonances. Following the MEC, a WPT prototype was designed, which was composed of a full bridge inverter, a LC resonant transmitter, a LC resonant receiver and a full bridge rectifier. The resonant frequency of the transmitter was designed to be slightly lower than the inverter operation frequency-446kHz to make an inductive load for the inverter so that all the MOSFETs operated in Zero-Voltage-Switching (ZVS) condition. For the experimental results, 300 W output power was obtained over a distance of 22cm with 84% overall efficiency.

Efficiency and Frequency Bifurcating Phenomenon Research Ofseries Resonance Converter Applied in a Contact-Less Power Transmission System

Study of Frequency Bifurcation Phenomenon of a Contact-Less Power Transmission System

Wireless Power Transfer with Additional Third Harmonic: Theoretical Analysis, Design, and Demonstration

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

A Method of Resonant Frequency Optimized Selection for a SP Inductive Coupled Power Transfer System

Investigation on Voltage Source Series Resonant Converter with Series Compensation for CEET

Realisation of Stable Output for Contact-Less Energy Transfer System with Multiple Loads

A Frequency Tuning Series-Series WPT System with Wide Coupling and Load Ranges

Design and Optimization of a Wireless Power Transfer System with a High Voltage Transfer Ratio

Optimal parameters design for series-series resonant converter for wireless power transfer

Simulation and Experimental Comparison of Different Coupling Mechanisms for the Wireless Electricity Transfer

Principles of adaptive resonance technology for contactless power transmission system

Study Of Detachable Transformer Using Fem On Contactless Power Transmission System

Study on Efficiency Maximization Design Principles for Wireless Power Transfer System Using Magnetic Resonant Coupling

Cascaded H7 Current Source Converter Based Power Transmission System And Fault Analysis

Design and test of capacitive power transfer coupling for wound field synchronous machines

Design of the resonant converter for the contactless inductive charging system

An Improved Design Method of High Efficiency Contactless Power Transmission in Ultrasonic Vibration System

Research on Transfer Mechanism and Power Improvement Technology of the SCC-WPT System

Series-Series/Series Compensated Inductive Power Transmission System with Symmetrical Half-Bridge Resonant Converter: Design, Analysis, and Experimental Assessment

Design of High Voltage, High Power and High Frequency Transformer in Lcc Resonant Converter