Abstract:Following the general guidance on the influence of the machining polarity in micro-EDM, usually a straight polarity is applied (with the tool electrode being connected to the negative pole of the generator output), since the bombarding of the “light” electrons on the workpiece is assumed to be the primary material removal mechanism. Therefore, a flipping of the polarity in the micro-EDM machining process shall result in a high volumetric relative wear, which has been experimentally verified. The initial objective of this research is to reduce the tool wear by inserting a diode in the discharge circuit to block the reverse current flow. However, in the experiments an even higher volumetric relative wear has been observed with the inclusion of a diode. To investigate in depth the influence of the alternating current flow on the tool-material interaction, a pulse counting method based on the detection of the current peak has been proposed to count the number of effective pulses. This counting of the effective sparks enables the subsequent analysis of the mean material removal per discharge and tool wear per discharge. The analysis of the measurements obtained in both sparking cases, with a diode and without a diode, indicates that the reverse current is contributing positively to the material removal on the workpiece and the volumetric relative wear. Therefore, it is not economically proper to block the reverse the current flow in micro-EDM milling. At lower open voltage, the simple empirical linear model without reverse current flow can still serve as a reference for the in-situ tool wear prediction and the subsequent tool wear compensation. However, a correction to the model has to be made at a setting of higher open voltage.

Study on the Transistor Type Pulse Generator for Micro-EDM

Basic Study on Pulse Generator for Micro-Edm

819 Study on Transistor-Type Pulse Generator in Micro EDM

Foundational Research on Pulse Generator Technology in Micro-EDM

Experimental Research on Pulse Generator for EDM of Non-Conductive Ceramics

Improvement of machining characteristics of micro-EDM using transistor type isopulse generator and servo feed control

Design and Experimental Study of a Pulse Generator with Controllable RC Circuit for Micro-EDM

Design and experimental study of a multi-mode controllable RC pulse generator for micro-EDM

Pulsed power supply of Tr-RC and Tr-RLC topologies for improvement of micro electrical discharge machining

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

Pulsed Power Supply with Ns-Pulsewidth for Micro EDM Based on Triode Avalanche Principle

Research of Multimode Pulse Power Supply for Micro-EDM

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

A High Energy Density Pulsed Power Supply for Micro EDM of High Aspect Ratio Holes

An EDM pulse power generator and its feasible experiments for drilling film cooling holes

Ns-pulsewidth Pulsed Power Supply by Regulating Electrical Parameters for AFM Nano EDM of Nm-Removal-resolution

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

Research on the Key Technologies of Micro Electro Discharge Machining

Design and Simulation of a Compact Sub-Nanosecond Pulse Generator Based on Marx's Circuit Theory of Field-Effect Transistors

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode