Abstract:In this paper, a new fault tolerant dc-ac converter-fed induction motor drive is proposed to maintain motor as close as possible to its desired normal operation under open- and short-circuit switch failures. The operational principles for fault detection and isolation schemes are provided. Two control strategies including predictive control and voltage mode-controlled PWM with integral-double-lead controller for two stage of the converter are presented in conjunction with the elaborated discussion. The control strategy determines appropriate switching states for continuous operation of the drive after a fault. The proposed topology makes it possible to integrate the minimal redundant hardware and full tolerance capability which is an important advantage of the proposed topology. Moreover, the most important advantages of the proposed topology are a fast response in a fault condition and low cost of the converter in comparison with the evaluated topologies. A Joule-integral-based method for selecting an appropriate rating of applied fuses has been presented to provide a reliable fault-isolation operation. Also, a comparison with currently available fault-tolerant dc-ac converters is given to show the merits of the proposed topology. Finally, the experimental results are presented to verify the validity of the theoretical analysis and industrial feasibility of the proposed converter.

Fault Protection and Fault-Tolerant Operation Method for Matrix Converter-Induction Motor System

A Novel Safe Shutdown Strategy for Matrix Converter Even under Fault Condition

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

High Performance Control of Matrix Converter Fed Induction Motor Drive System

DC-AC Converter-Fed Induction Motor Drive With Fault-Tolerant Capability Under Open- and Short-Circuit Switch Failures

Fault-Tolerance Analysis Of Multi-Phase Single Sided Matrix Converter For Brushless Dc Drives

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Open Circuit Fault-Tolerant Control of Novel Matrix-Torque-Component Machines Based on Multiple Operation Modes

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Fault Tolerant Control for Open Winding Brushless DC Motor with Power Device Failure

Twofold Fail-Work Remedy for Reconfigurable Driver and Windings of Four-Phase Permanent Magnet Fault-Tolerant Motor System

An Improved Matrix Converter Fed Induction Motor Vector Control Drive with Output Voltage Error Cancellation

Fault-tolerant Control of Multiphase Induction Machine Drives Based on Virtual Winding Method

Fault Tolerant Inverter Based Direct Torque Control for Permanent Magnet Synchronous Motor

Fault-tolerant Control Strategy for Five-phase Permanent Magnetic Synchronous Motor under Single Phase Open-circuit Fault Condition

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Modeling and control of 15-phase induction machine under one phase open circuit fault