Abstract:In this paper, the authors present a stress wave-based active sensing method to detect the crack in FRP-reinforced concrete beams. The embedded smart aggregates (SAs), which utilize Lead Zirconate Titanate (PZT) as transducers, are employed in this research to generate and sense the stress wave. Three specimens are involved in the experimental program and each is made of concrete, longitudinal distributed reinforcement, steel stirrups, main bar (FRP bar or steel bar), and four SAs. A pair of SAs installed on the lower part of the main bar and the other pair of SAs mounted on the upper part of main bar are utilized to monitor the crack occurrence and development in the three test specimens. The signals received by the SA sensors are analyzed in both time domain and frequency domain. The wavelet packet energy is used to extract damage features. The applied load–vertical displacement curves of mid-span in the specimen are obtained. Experimental results show the test specimens experience crushing failure when the concrete compression exceeds its compressive strength. Increasing the contact area between FRP bar and concrete can effectively improve the cracking load of the FRP-reinforced concrete beam and reduce the cracking speed and depth of FRP-reinforced concrete beam; on the other hand, increasing the elastic modulus of the main bar can slow down the crack development of concrete on the upper side of the main bar and decrease the displacement of reinforced concrete beam during the loading test process. The research results show that the developed piezoceramic-based active sensing method, though low-cost, can monitor the crack-induced damage and estimate the process of damage degree in real-time, and has potentials to provide an early warning of crack occurrence and development for FRP-reinforced concrete beams.

Research on CFRP alarm sensors

Research on prestressed CFRP alarm sensors

A New Electrical Resistance Measurement Method of Carbon Fiber-Reinforced Polymer Tubes Based on C⁴D Technique

FRP Confined Smart Concrete/mortar

Distributed Sensing of RC Beams with HCFRP Sensors

Self-Sensing CFRP Fabric for Structural Strengthening and Damage Detection of Reinforced Concrete Structures

Crack Monitoring Method for an FRP-Strengthened Steel Structure Based on an Antenna Sensor

A Monitoring Method Based On Fbg For Concrete Corrosion Cracking

Self-diagnosis of Structures Strengthened with Hybrid Carbon-Fiber-reinforced Polymer Sheets

Experimental Investigation of Self-Sensing Carbon Fiber Reinforced Cementitious Composite for Strain Measurement of an RC Portal Frame

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Detection of CFRP-concrete interfacial defects by using electrical measurement

Debonding Detection of Reinforced Concrete (RC) Beam with Near-Surface Mounted (NSM) Pre-stressed Carbon Fiber Reinforced Polymer (CFRP) Plates Using Embedded Piezoceramic Smart Aggregates (SAs)

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

Crack Detection of FRP-Reinforced Concrete Beam Using Embedded Piezoceramic Smart Aggregates

Corrosion monitoring of PC beams with a novel type of HCFRP sensors

Preliminary Experiment of CFRP Displacement Direct Measurement with Eddy Current Sensor

Self-Diagnosis of Hybrid CFRP Rods and As-Strengthened Concrete Structures

Cure monitoring and damage identification of CFRP using embedded piezoelectric sensors network

Behavior of RC Beams Strengthened Using Steel-Wire-Carbon-Fiber-Reinforced Plates

Experimental Research on Concrete Crack Recognizing and Monitoring Based on Distributed Fiber Sensor