Abstract:Ionization chambers are essential for activity determinations in radionuclide metrology. We have developed a high-precision integrating-differentiating (int-diff) system for measuring small currents. It is anticipated to enhance the ionization current measurement capability of the 4$\pi\gamma$ ionization chamber radioactivity standard at the National Institute of Metrology (NIM), China. Besides, it has broad application prospects in physical experiments and fundamental metrology. The design of the measurement system is optimized through circuit analysis and simulation. The structure of the integrating capacitor array is redesigned to reduce the error of the amplification gain, and a relay is used as the reset switch to achieve improved noise and bias. The digital readout and control module is also enhanced in terms of flexibility and functionality. High-precision test platforms utilizing the standard small current source at NIM China and an ionization chamber were developed to evaluate the performance of the system. The results demonstrate an ultra-low noise floor <1 fA/$\surd$Hz and a low current bias <1 fA, as well as a low temperature coefficient of the amplification gain of 2.1 ppm/{\textdegree}C. The short-term stability and linearity of the gain are also tested and exhibit comparable indicators to those of the Keithley 6430. Reasonable results are obtained in the long-term reproducibility test. Therefore, the system enables high-precision measurements for small direct currents and shows promise for applications in ionization chambers.

Network Measuring System for High Precision Stabilized Current Supply

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Development of radiation tolerance evaluation and measurement system for spaceborne D/A converter

High Precision Standard Testing System for Dcct

A Low-Noise Int-Diff Small Direct Currents Measurement System with Two-Stage Amplifier and Digital Differentiator

Local Intelligent Controller for High Precision Magnet Power Supply

Design of Automatic Test System for Power Supply Based on GPIB Bus

A High Current Measurement Experimental System Using Magnetic Sensor Arrays

Performance Optimizations and Evaluations for the Small Direct Currents Measurement System

High Precision Measuring Technology and Algorithm on Acquisition Terminal of Power Load Control and Management System

Combined Digital Electronic Current and Voltage Transducer

Data Acquisition and Processing System Based on DSP and CAN Bus

Experimental investigation on optical current transducer's long-term operation stability

Small Signal Measuring System Based on In-system Programmability Programmable Analog Devices

Design and Implementation of Highly Accurate Current Measurement Acquisition Card

Design and Test of High Precision Dynamic Power Supply

A Calibration Method for Power Metering System with Electronic Instrument Transformers

Integration and Implementation of Measurement System for Missile-Radome Electrical Capability

Experiment on site operational stability of optical current transformer

Design and realization of high-precision digital control direct current power supply

Implementation of Distributed Potential Monitoring Data Acquisition System