Abstract:In the recent ten years, the Global Navigation Satellite System (GNSS) processing has experienced a fast development in many areas including the increasing number of frequencies, the higher quality of positioning instruments, e.g. the receiver clocks and the satellite clocks, and more integrated modeling and calculation strategies. This thesis includes investigations of diﬀerent modeling and parameterization methods in modern GNSS positioning with the focus on three important positioning error sources: the receiver clock errors, the phase ambiguities and the ionospheric delays. The thesis shows that making use of the high-quality receiver clocks and applying appropriate receiver clock modeling can help to improve the kinematic height estimates, which are highly correlated with the receiver clock parameters. An eﬃcient pre-elimination and back-substitution strategy of epoch parameters with relative clock constraints between subsequent and near-subsequent epochs has been developed to enable processing of, e.g., high-rate data. A detailed analysis of the relationship between the clock quality and the improvement of kinematic heights has been performed. Studies were also conducted to decorrelate the receiver clock parameters, the kinematic heights and the troposphere parameters. Experiments with real data have shown that appropriate deterministic and stochastic clock models can also be helpful to increase the resolution of the estimated Zenith Path Delay (ZPD) parameters without obvious degradation of the stability of the kinematic heights. The second aspect of the thesis focuses on the resolution of triple-frequency phase ambiguities with diﬀerent linear combinations. A complete analytical investigation of Geometry-Free (GF) and Ionosphere-Free (IF) triple-frequency phase ambiguity resolution with minimized noise level has been performed for diﬀerent frequency triplets. The analysis was done separately for the best two linear combinations and the third one. Experiments have shown that the fractional parts and the formal errors of the combined ambiguities of the best two linear combinations are relatively small for Galileo E1, E5b and E5a and GPS L1, L2 and L5 triplets, while the third linear combination remains a challenge. Further analysis with the geostationary satellites of the Beidou Navigation Satellite System (BDS) elaborated in the framework of this thesis has also conﬁrmed that the

Data Processing and Analysis of EGNOS Trial in China Area

Analysis of Post-Processed Pseudorange-Based Point Positioning with Different Data Sources for the Current Galileo Constellations

Accuracy Analysis of BeiDou-3/GPS Real-Time Precise Common View Time Transfer Based on Carrier-Phase

Simulation Analysis of GNSS Geometric Performance

Analysis of BDS/GPS Signals’ Characteristics and Navigation Accuracy for a Geostationary Satellite

GLONASS signal characteristics analysis and navigation performance for geostationary satellites

Study on the algorithms to correct and compensate for GLONASS signal deviation based on GNSS receiver

A Comprehensive Signal Quality Assessment for BDS/Galileo/GPS Satellites and Signals

Performance of GNSS space service for geostationary autonomous operations

Gnss Receiver Techniques Based On High Earth Orbit Spacecraft

Advanced Modeling and Algorithms for High-Precision GNSS Analysis

Assessment of FY-3E GNOS II Radio Occultation Data Using an Improved Three-Cornered Hat Method

Validation of the Accuracy and Convergence Time of Real Time Kinematic Results Using a Single Galileo Navigation System

Implement and Experiment of GNSS Receiver Software

Analysis of GPS/EGNOS Positioning Quality Using Different Ionospheric Models in UAV Navigation

Analysis of Quasi-Zenith Satellite System Signal Acquisition and Multiplexing Characteristics in China Area

A Novel GNSS Quality Control Method With Satellite Geometric Network for Dynamic Urban Positioning

High-Rate Attitude Determination of Moving Vehicles with GNSS: GPS, BDS, GLONASS, and Galileo.

Investigation of real-time kinematic multi-GNSS precise point positioning with the CNES products

DFMC SBAS service performance analysis of multi-GNSS based on BDS-3 in different regions

A DYNAMIC PERFORMANCE EVALUATION METHOD FOR DGPS RECEIVERS UNDER LINEAR PARALLEL-TRACKING APPLICATIONS