Abstract:Titania thin films with ordered nanostructures are of general interest in fields of photocatalysis, gas sensors, energy storages, energy conversions, etc. In this study, we report a low‐temperature crystallization and the simultaneously occurred morphology change of titania thin films in a dilute H2SO4 solution. Amorphous titania nanowire arrays were fabricated by a Ti–H2O2 interaction, which transformed to crystallized nanoflower arrays through a dissolution–precipitation route during the subsequent acid treatments. The nanoflowers were doped with nitrogen and also incorporated with sulfate ions. An increasing H2SO4 concentration resulted in larger nanoflowers with higher anatase content; but the crystallinity reduced. The low‐temperature‐derived nanoflower arrays possessed high density of surface hydroxyl groups and defect VO‐Ti3+ sites, which contributed to a high absorption and enhanced photodegradation efficiency of rhodamine B in water under the illumination of UV–visible light during the first several runs of photocatalytic evaluations. The beneficial surface defects diminished gradually with increasing runs; however, the average reaction rate constants of the acid treated films are still superior to that of the calcinated one, which can be attributed to several structural parameters such as the nanoflower morphology, incorporation of sulfate ions, and the coexistence of anatase and rutile.

Low Temperature Preparation of Titania Coated Pan Fiber and Its Photocatalytical Property

Preparation and Properties of TiO2/Bentonite Composite Photocatalytic Materials at Room Temperature

Low Temperature Synthesis of Few-Layer Titanate Nanobelts on Ti Mesh and the Hot-Water Induced Transformations to Highly Photocatalytic Active Titania Nanorods

Low‐Temperature Transformation of Titania Thin Films from Amorphous Nanowires to Crystallized Nanoflowers for Heterogeneous Photocatalysis

Fabrication and Photocatalytic Activity of Tio2 Nanofiber Membrane

Polyaniline nanowires on TiO2 nano/microfiber hierarchical nano/microstructures: Preparation and their photocatalytic properties

Preparation of TiO2 Nanofibres and Influence of Calcination Temperature on Photocatalytic Activity

Flexible Polyaniline-Coated Tio2/Sio2 Nanofiber Membranes with Enhanced Visible-Light Photocatalytic Degradation Performance

PPy-assisted fabrication of Ag/TiO2 visible-light photocatalyst and its immobilization on PAN fiber

Low-Temperature Preparation of Macroporous Anatase TiO2 Thin Film and Its Photocatalytic Activity

Surface Characterization of Thin Titania Films Prepared at Low Temperatures

Low Temperature Synthesis of Crystalline Mesoporous Titania with High Photocatalytic Activity by Post-Treatment in Nitric Acid Ethanol Solution

Low-temperature Preparation and Microwave Photocatalytic Activity Study of TiO2-mounted Activated Carbon.

Photocatalytic zinc oxide on flexible polyacrylonitrile nanofibers via sol–gel coaxial electrospinning

Supercritical Fluid Processing of Thermally Stable Mesoporous Titania Thin Films with Enhanced Photocatalytic Activity

In situ synthesis of TiO 2/polyethylene terephthalate hybrid nanocomposites at low temperature

Low-temperature preparation of TiO2 films and enhancement of their photocatalytic activity by organic semiconductor

Removal of a Cationic Dye by Adsorption / Photodegradation Using Electrospun PAN / O-MMTComposite NanofibrousMembranes Coated with TiO 2

Titanium Dioxide Fibers Prepared by Sol–gel Process and Centrifugal Spinning

Preparation of Nanoporous Titania Films by Surface Sol−Gel Process Accompanied by Low-Temperature Oxygen Plasma Treatment

Synthesis of TiO2@lignin based carbon nanofibers composite materials with highly efficient photocatalytic to methylene blue dye