Abstract:<p>This paper presents a semi-analytical finite strain solution for circular roadways excavated in a strain-softening rock mass with a non-associated flow rule. The evolutions of both strength parameters and Young's modulus are considered, and the finite strains are applied to describe both the elastic and plastic behaviors with the logarithmic strain in Lagrangian coordinates. By transforming the derivative of displacement with a new variable that is correlated with displacement, the stress and displacement in the elastic region are obtained in the form of integral equations. Considering the assumption of constant material parameters within a very small region, the plastic region is divided into a number of concentric annuli, whose closed-form solutions of displacement and stress can be recursively obtained. The solution is validated by similarity solutions and numerical simulation. Both the roadway wall displacement and thickness of the plastic (residual) region appear to be smaller than those of the small strain solution. For the elasto-perfectly-plastic rock mass, the finite strain solution is approximately the same as that of small strain solution. However, for the strain-softening rock mass, with the decrease of Young's modulus, the thickness of plastic and residual regions shows the first increase and then decrease trend, finally approaching nil; the difference between the thickness of softening and residual region gradually decreases. The decreasing Young's modulus deterioration coefficient and increasing dilation angle significantly produce the displacement. Both the displacement and the thickness of plastic and residual regions decrease with the increase of Poisson's ratio. When Young's modulus is large, the tangential stress gradually decreases with the increasing radius. When Young's modulus is small, the tangential stress firstly increases to a maximum value, then decreases gradually. Different from the small strain solutions, the roadway wall displacement of finite strain solutions cannot be larger than the excavation radius, which is in compliance with the practical underground engineering condition. The predicted displacement and thickness in both plastic and residual regions are in accordance with the field test results.</p>

Analytical Solution of Complete Stress-Strain Curve in Uniaxial Compression Based on Gradient-Dependent Plasticity

Analysis of Strain Localization in Porous Media with Transversely Isotropic Elasticity under Undrained Conditions

Biaxial Creep Test Study on the Influence of Structural Anisotropy on Rheological Behavior of Hard Rock

Strain Gradient Plasticity Solutions of Plastic Region Radius for a Borehole Problem

Influence Analysis of In-situ Stress on Plastic Zone of Circular Chamber Surrounding Rock

Theoretical Solution for Stress and Strain Distributions Induced by Generalized Elastic Constant Variation in Rock Mass

Study of Plastic Shear Localization Via the Flow Theory of Mechanism-Based Strain Gradient Plasticity

Elastoplastic strain localization analysis of soil slope

A Strain Hardening Model for the Stress-Path-dependent Shear Behavior of Rockfills

An experimental investigation and mechanical modeling of the combined action of confining stress and plastic strain in a rock mass

Stress Distribution in Direct Shear Loading and its Implication for Engineering Failure Analysis

The stress distribution around a thick-walled cylinder by a proposed constitutive model for rocks

Size-dependent Nonlinear Post-Peak Stress-Strain Curve of Normal Concrete in Uniaxial Compression

Simplified method to identify full von Mises stress-strain curve of structural metals

Numerical Simulation of the Shear Behavior of Rockfills

A finite strain solution for strain-softening rock mass around circular roadways

A Model for Athermal Strain Localization in Dry Sheared Fault Gouge

Experimental Study on Shear Stress-Displacement, Creep and Shear Slip Instability Behavior of Rock Fractures

Stress Wave Propagation in Viscoelastic-Plastic Rock-Like Materials

Shear Banding Analysis of Geomaterials by Strain Gradient Enhanced Damage Model

A Strain Hardening Model for Rockfills