Abstract:Titanium alloy can be found in numerous applications, such as chemical, aerospace, and energy industries, among other sectors, due to its excellent performance. Nevertheless, the possible uses of a variety of titanium-based alloys have been greatly restricted by their low hardness and inadequate resistance to wear. Therefore, in this research work, WC–Cu composite electrode assisted electrical discharge coating (EDC) is used for improving microhardness (MH) and surface integrity of Ti–6Al–4V alloy. By utilizing powder composite electrode, the conductivity of the electrode can be increased, which provides controlled electric spark, resulting in uniform deposition. In order to increase the rate of deposition, the terminal of the EDM has been changed as WC–Cu composite electrode as anode and workpiece as cathode. Response surface methodology is used for studying the variables including compacting pressure (MPa), discharge current ( I ), pulse on time ( T on ). In addition, microstructure, elemental analysis and coating interface of deposited Ti–6Al–4V alloy are investigated through scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS). The surface roughness of 8.86 μm was achieved at 400 MPa, 6 A, and 40 μs. The maximum MH of 988 HV was obtained at 400 MPa, 10 A, and 80 μs. The MH of the deposited layer is around 2–3 times harder than base material. Moreover, a greater adhesion strength coated layer was ∼118 N, which permits the alloy to have improved wear resistance. It was concluded that using a high-pressure electrode with lower settings resulted in an improved surface finish, while higher settings led to increased MH.

Study on electrical discharge coating with TiC ceramic layer

Two-Layer Nanocomposite TiC-Based Coatings Produced by a Combination of Pulsed Cathodic Arc Evaporation and Vacuum Electro-Spark Alloying

Surface modification process by electrical discharge machining with a Ti powder green compact electrode

Study on Surface Modification by Using Electrical Discharge Machining

A Surface Modification Method By Edm And Its Application To Cutting Tools

Study on method of surface ceramic deposition by EDM

Performance and Microstructure of TiN/Cu EDM Electrodes

A Surface Modification Method by Using EDM

Ceramic-metal Composite Coating on Steel Using a Powder Compact Tool Electrode by the Electro-Discharge Coating Process

Friction and wear behaviors of TiCN coating based on electrical discharge coating

Progress of Surface Modification for Ceramic Cutting Tools by Pulsed High Energy Density Plasma

Experimental Investigation of EDM Parameters for TiC/Ni Cermet Machining☆

Enhancing microhardness and surface integrity of Ti–6Al–4V alloy using WC–Cu composite electrode aided electrical discharge coating

Surface modification of tungsten carbide cobalt by electrical discharge coating with quarry dust powder: an optimisation study

Discharge Characteristics in Electrochemical Discharge Machining of Ceramic-coated Ni-superalloy

Study on the Properties of TiC Coating Deposited by Spark Discharge on the Surface of AlFeCoCrNiCu High-Entropy Alloy

Ti(C,N) Hard Coatings Prepared by Pulsed High Energy Density Plasma

Structure of the Coatings Onto Ceramic Cutting Tools Deposited by Pulsed High Energy Density Plasma

Performance and increased fatigue life for a Ti workpiece produced by the EDM process

Machining characteristics in ultrasonic vibration-assisted powder-mixed electrical discharge machining of TiN ceramics

Micro Electrical Discharge Machining of Ultrafine Particle Type Tungsten Carbide Using Dielectrics Mixed with Various Powders