Abstract:This paper discusses a nanometer level precision alignment technique as applied to highly efficient micro optics packaging using heat curable adhesives. To achieve a fast curing process, we deposit microwave energy to the spot where optical bonding is desired. Conventional microwave heating technique, however, as we know it, relies on large mass ratio between the epoxy and the components to be bonded. In order to improve the efficiency of heat absorption by the tiny amount of adhesive used for micro optics packaging, we pre-process the components to be bonded, by first polishing the bonding surfaces and then depositing a very thin layer of metalized film on them. An infrared (IR) remote temperature sensor is utilized to monitor the temperature of the adhesive (to prevent over heating). An automated system can then adjust the power output of the microwave so that a fairly constant curing temperature can be maintained. During the fast curing process, pre-alignment of micro optics, such as fiber optic coupler, will inevitably suffer minor misalignment due to non-uniform heating of the components. To compensate for this side-effect, we have developed a real time alignment monitoring and feedback controlled system. As an example to packaging fiber couplers, such a system can monitor the insertion loss (IL) of a component in real time while the adhesive is being cured by the microwave energy. A 3-dimensional piezo-electric transducer (PZT) is employed to achieve the x-, y-, and z-axis alignment. A level of 10 nanometer alignment can be readily achieved which in turn leads to an IL sensitivity of as small as 0.004dB. An improvement of a packaging efficiency as high as 150 times has been demonstrated, compared to conventional blind oven curing process. Yield of micro optics packaging is also expected to increase due to the use of real time alignment process.

Microfabricated Clamps for High-Precision Passive Alignment and Packaging of Optical Fibres in Optoelectronics Devices

Packaging of optical fibers using microfabricated nickel clamps

Recent Progress in Optical Micro/Nanofiber Technology

A Novel Device of Passive and Fixed Alignment of Optical Fiber

Novel Device of Passive and Fixed Alignment of Optical Fiber Using SU-8 Photoresist

Micro Optics Alignment with Nanometer Precision and Real-Time Bonding Using Microwave Technology

Microfiber and Nanofiber Optics: Principles and Applications

Fabrication Methods and High-Precision Diameter Control Techniques of Optical Micro-/Nanofibers

Fabrication-friendly High-Efficiency Silicon Nitride Grating Coupler

High-efficiency Grating Coupler Based on Fast Directional Optimization and Robust Layout Strategy in 130 Nm CMOS Process.

Flexible Passive Integrated Photonic Devices with Superior Optical and Mechanical Performance.

Fabrication of optical components with nm- to mm-scale critical features using three-dimensional direct laser writing

Micromanipulation robot for automatic fiber alignment

Design and Fabrication of Micromechanical Variable Fiber-Optic Attenuator

MEMS-Based Integrated Optical Fiber Connector

An alignment approach for coupling mounts using a fiber ended micro-lens

Fabrication of micro-optical devices at the end of a multimode optical fiber with negative tone lift-off EBL

Multi-Axial Elastic Averaging for Sub-Micron Passive Alignment of Photonic Components

Polymer Micro or Nanofibers for Optical Device Applications

Development of 1×16 MEMS optical fiber connector array

Single- and multi-layer micro-scale diffractive lens fabrication for fiber imaging probes with versatile depth-of-field