Abstract:This study designs and implements the piezoelectric MEMS scanning mirror with large scan angle and reflection area for light beam manipulating applications. In this design, the scanning mirror has a large mirror plate (3 mm in diameter) supported by two T-shape torsional springs. The U-shape piezoelectric cantilever acts as the actuator to drive the scanning mirror through the transmission spring. The analytical model is established to provide the design guideline of transmission spring to increase the scan angle. In application, the proposed designs are fabricated on the SOI (silicon on insulator) wafer deposited with the PZT film. Measurements indicate the fabricated mirror could reach an optical scan angle of 140-degree (mechanical scan angle of ± 35-degree) when driving at its resonant frequency of 1.5 kHz with a unipolar driving voltage of 42 V. Moreover, no vacuum environment is required for the presented scanning mirror to achieve the above scan angle. This is an extremely large optical scan angle for the MEMS scanner with a mirror plate of 3 mm in diameter. In addition, another U-shape piezoelectric cantilever serves as the position sensor to detect the scan angle of mirror plate. The sensing signals show good linearity with the scan angles and can be exploited as the feedback control. Measurements also demonstrate that the micro scanner could withstand 1500 g shock loading, and the deviation of scan angle is less than 10% after the cycling test under 10 Vpp resonant driving in 95%RH and room temperature for 0.2 billion cycles.

A Method of Increasing Scanning Frequency by Broad-Beam and Small-Angle Scan

Optical Design and Fabrication of the off Axis Paraboloid and Ellipsoidal Mirrors of Beam Line for Synchrotron Radiation Biological Spectroscopic Experiments

Subaperture alignment technique for large aperture mirrors

Optimization for Imaging Through Scattering Media for Confocal Microscopes with Divided Elliptical Apertures.

Wide Angle and High Frequency Resonant Piezoelectric MEMS Mirror for Laser Beam Scanning Application

Development of an Electrostatic Comb-Driven MEMS Scanning Mirror for Two-Dimensional Raster Scanning

On the design of piezoelectric MEMS scanning mirror for large reflection area and wide scan angle

High resolution micromachined scanning mirror

The Improvement of Micro-Torsional-Mirror for High Frequency Scanning

A MEMS-based terahertz broadband beam steering technique

Experimental Investigation on the Principle of a Two-Dimensional Scanning Micro-Mirror

Large-Aperture Khz Operating Frequency Ti-Alloy Based Optical Micro Scanning Mirror For Lidar Application

Modeling and Optimization of a Novel ScAlN-Based MEMS Scanning Mirror with Large Static and Dynamic Two-Axis Tilting Angles

Construction of freeform mirrors for an off-axis telecentric scanning system through multiple surfaces expansion and mixing

Construction Method Through Forward and Reverse Ray Tracing for A Design of Ultra-Wide Linear Field-Of-View Off-Axis Freeform Imaging Systems

Note: Symmetric Modulation Methodology Applied In Improving The Performance Of Scanning Tunneling Microscopy

Design Study of a Large-Angle Optical Scanning System for MEMS LIDAR

Bifocal design and aperture phase optimizations of reflectarray antennas for wide-angle beam scanning performance

Novel Bow-Shape Transmission Springs for Piezoelectric MEMS Mirror with 180-Degrees Optical Scanning Angle

Design of a Bi-Axial Piezoelectric MEMS Scanner with Tri-Gimbal Structure for Scanning Pattern Enhancement