Abstract:High power semiconductor laser is a kind of photoelectric device with high efficiency and high stability, the performance of its drive system directly affects its output characteristics and service life. In order to solve the problems of stability and robustness of the output power of the semiconductor laser, a semiconductor laser driving power supply with high efficiency, low ripple and strong anti-interference ability was developed. In this paper, the topology of the LCC resonant converter is adopted (LCC refers to the type of resonant converter, because its resonator is composed of an inductor L and two capacitors C, it is called LCC resonant converter). The power supply adopts full-bridge LCC resonant power topology. Firstly, a mathematical model is established to analyze the relationship between LCC resonator parameters and output current gain. Secondly, an LCC resonator parameter design method is proposed to reduce the current stress of components, and the variable frequency phase shift (PFM-PWM) composite control strategy and linear active disturbance rejection control (LADRC) algorithm are proposed, which not only ensures the zero voltage (ZVS) conduction of MOS (Metal-Oxide-Semiconductor) tube, but also reduces the on-off loss of MOS tube. The PFM-PWM composite control strategy and LADRC algorithm not only improve the power efficiency of the drive power supply, suppress the output current ripple, but also ensure that the output current of the drive power supply is stable when the input voltage, load and parasitic parameters of the circuit change. Finally, the simulation and experimental results show that the power supply can be continuously adjustable in the output current range of 0–40 A, the current ripple is less than 0.8%, and the working efficiency is up to 92%. It has the characteristics of high stability, small ripple, high efficiency, low cost and good robustness.

An Extremely Fast and High-Power Laser Diode Driver Module

High Pulse Repetition Frequency Fiber-Coupled Laser-Diode Module

Pulsed Power Modulated Driving Technology with High Output Power for Laser Fuze

A Kind of High Bit Rate Laser Diodes Driver

Design and Implementation of a Power Semiconductor-Based Switching Mode Laser Diode Driver

A Load-Adaptive Driving Method for a Quasi-Continuous-Wave Laser Diode

High Power Conductively Cooled Laser Diode Array Operating under Hard Pulse Condition

Modulated High Power and Narrow Pulse Width Laser Drive Circuit for Lidar System

High current short pulse driver using a high power diode laser for optoacoustic biomedical imaging techniques

An Adjustable Amplitude And Pulse-Width Laser Modulation Driver With Active Feedback For Qkd Experiments

Step-Pulse Modulation of Gain-Switched Semiconductor Pulsed Laser

High Speed Driving of a Gain-Switched Laser Diode with an Exponential Transmission Line

Design of High-Performance Driving Power Supply for Semiconductor Laser

A Fully-integrated GaN Driver for Time-of-flight Lidar Applications

Large current nanosecond pulse generating circuit for driving semiconductor laser

A 32Gb/s-NRZ, 15GBaud/s-PAM4 DFB laser driver with active back-termination in 65nm CMOS

Large current nanosecond pulse generating circuit for driving semiconductor laser diode

Design of LD Current Drivers of Pump-Modules in Fiber Amplifiers

High-power 910 Nm Vertical-Cavity Surface-Emitting Laser Arrays for Light Detection and Ranging

An 8-A Sub-1ns Pulsed VCSEL Driver IC with Built-In Pulse Monitor and Automatic Peak Current Control for Direct Time-of-Flight Applications.

An Efficiency Improvement Driver for Master Oscillator Power Amplifier Pulsed Laser Systems