Abstract:Multilevel inverters typically require a large number of power switches, increasing the likelihood of faults and compromising system reliability. To enhance inverter reliability, this article introduces a five-level multilevel inverter with fault-tolerant capabilities. This topology employs two DC voltage sources with four unidirectional and two bidirectional power IGBT switches. A fault-tolerant control strategy has been developed to reconfigure the topology whenever an open circuit fault occurs in a switch. To evaluate the proposed topology, a loss analysis and efficiency assessment were conducted using Piecewise Linear Electrical Circuit Simulation. The results showed 36.35 W of power loss and an efficiency of 96.49% for 1 kW of output power. The total standing voltage per unit and cost function of the proposed topology are 6 and 4.2, respectively, which are minimal compared to other fault-tolerant topologies. Furthermore, a laboratory prototype was developed using a DSPACE-1202 controller to validate the results. The voltage stress on the power devices was found to be reduced by 25–50% under various post-fault conditions compared to healthy condition. The proposed topology is able to withstand OC fault in single unidirectional switch or multiple unidirectional switches and still be able to generate 64% of the rated output rms voltage. If an OC fault occurs in any of the bidirectional switches, then the topology is fully tolerant by generating 100% of the rated output rms voltage. The reliability for the proposed topology is performed using Markov chain rule and proved that the proposed topology is superior to other topologies.

A MULTILEVEL CONVERTER TOPOLOGY WITH SELF-REPAIR ABILITY

A Multilevel Converter Topology with Fault-Tolerant Ability

A MULTILEVEL CONVERTER TOPOLOGY WITH REDUNDANCY ABILITY

A fault-tolerant T-type three-level inverter system

A High Step-up Multilevel Inverter with Minimized Components Featuring Self-balancing and Continuous Input Current Capabilities

Cascaded Half-Bridge Multilevel Inverter with Reduced Number of Power Switches

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

A Single-Phase Multilevel Inverter Topology with Fault Tolerant Capability for Single and Multiple Switch Failures

A New Transformerless Cascaded Multilevel Converter Topology

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

A Modular Multilevel Converter with Boosting, Self-Balancing, and Scaling Capabilities for High- Voltage Transformerless PV Applications

An Improved Hybrid Multilevel Converter For Renewable Energy Generation

A HYBRID CLAMPED MULTILEVEL INVERTER WITH NEUTRAL POINT VOLTAGE BALANCING ABILITY

Research on Combined Multilevel Converter Topologies

Multilevel Converter Topologies and Two Novel Topologies

A Topology-Reconfigurable Fault-Tolerant Two-and-Single Stage AC–DC Converter for High Reliability Applications

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

Multilevel Circuit Topologies Based On The Switched-Capacitor Converter And Diode-Clamped Converter

Fault-Tolerant Multiparallel Three-Phase Two-Level Converters With Adaptive Hardware Reconfiguration

A novel transformerless cascaded multilevel converter topology

A Multilevel Topology by Combination of Switched-capacitor and Diode-clamped Circuits