THE MEASUREMENT OF THE THERMAL ENERGY STORAGE CAPACITY OF PHASE CHANGE MATERIAL OR LATENT HEAT STORAGE COMPONENT USING SINGLE THERMOSTAT METHOD

Hong Ye,Meng Xu,Bin Xu,Shuangyong Zhuang,Xinshi Ge

DOI: https://doi.org/10.3321/j.issn:0254-0096.2005.06.017

2005-01-01

Abstract:A single thermostat method with quantitative water was developed for measuring the thermal energy storage capacity of the phase change material or latert heat storage component.the water was evenly heated from temperature T_1 to T_2,the thermal losses of the surfaces of the thermostat were measured by several heat flox meters,subtracting the thermal losses from the total electric energy consumed in the heating process,the energy consumed for heating the water can be figure out as Q_w;then dip the phase change material or latent heat storage component in the water,adjust the temperature to T_1,evenly heating the water to temperature T_2,measure the thermal losses using the heat flux meters,subtract thermal losses from the total electric energy used and the electric energy consumed for heating the water and the phase change material can be obtained as Q_(w+pcm);the electric energy consumed for heating the phase change material from T_1 to T_2 is equal to Q_(w+pcm) minus Q_w,which is just the thermal energy storage capacity of the phase change material of latent heat storage component between the temperature zone [T_1,T_2].The result of the test of a form stable phase change material using this method was compared to that of the DSC method.The error is less than 2%.This method was also used to measure the thermal energy storage capacities of the mixtures of phase change grains and concrete.