Abstract:The paper describes an advanced blading concept for highly loaded turbomachinery, named as Blended Blade and EndWall(BBEW). It implies the following three separate aspects or any of their combinations, i.e. increasing the dihedral between blade surface and endwall as much as possible, increasing the minimum curvature radius of curved transition surface that connects the blade with the endwall, and decreasing the streamwise gradient of the dihedral as the dihedral reduces streamwise. To the knowledge of the authors this is the first approach reported in the open literature that try to control corner separations and horse-shoe vortex(HSV) systematically under the guidance of the Rules of Dihedral (RD). In this paper, BBEW is applied to NASA rotor 67 which is featured by hub corner separation at the suction side and intensive HSV originating from blade leading edge at the hub. Two successive BBEW modifications are made to promote the performance of rotor 67. First, only a curved transition surface is designed to cover the hub corner at the suction side. Emphasis is paid on the streamwise distribution of the minimum curvature radius. Then, the second curved transition surface is added at the leading edge in near hub part. The nearby streamwise gradient of the dihedral is changed from infinity to a finite. Numerical tests showed that the implementation of BBEW had not only nearly eliminated the hub corner separation, but also weakened the leading edge HSV. Performance improvements are observed throughout its operation range. The work presented makes a contribution to a fully 3-D blading methodology for higher aerodynamic loading, engine efficiency and specific thrust.

Edge Matching - Part I: Theory And Implementation

Edge Matching - Part Ii: Numerical Investigations

Edge Matching for Unsteady Design of Turbomachinery(ⅱ) Numerical Investigations

EXPLORATION ON INFLUENCES OF EDGE MATCHING ON UNSTEADY FLOW OF TURBOMACHINERY

Edge-Matching Technique for Unsteady Aerodynamic Design of Turbomachinery

Optimization of Endwall Contours of a Turbine Blade Row Using an Adjoint Method

Turbine Blade Row Optimization Through Endwall Contouring by an Adjoint Method

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Secondary Flow Reduction By Blade Redesign And Endwall Contouring Using An Adjoint Optimization Method

Maximizing 3D Clocking Effect by the Guidance of Edge Matching

Effect of Trailing-Edge Modification of A Mixed-Flow Pump

Numerical Investigations about the Aerodynamic Performance of the Cascade in Unsteady Environment

Blade Envelopes Part II: Multiple Objectives and Inverse Design

Influence of different blade trailing edges on energy performance of impellers in a mixed-flow nuclear main pump

Numerical Studies on Application of Blended Blade and Endwall Technique on Transonic Centrifugal Compressor

Trend of Full Three-dimensional Blading Techniques for High Performance Turbomachinery

Investigation of non-axisymmetric endwall contouring in a high loaded turbine stator cascade

Fluid-thermal-structural interaction of aerodynamically heated leading edges

An Evaluation Strategy of Control Method for Corner Separation/Stall in Compressor Cascades

NUMERICAL INVESTIGATION ON HOT STREAK MIGRATION UNDER THE GUIDANCE OF EDGE-MATCHING TECHNOLOGY

Numerical Studies On Improving Performance Of Rotor-67 By Blended Blade And Endwall Technique