Abstract:As the parameters of the photoelectric detector have important effects on the performance of the dispersive spectrometers, it is necessary to detail the discrete sampling process of the photoelectric detector array. In the present paper, the sampling model was setup, and the effects on the sampling results caused by the spatial frequency of the cosine signal, the width of the sampling pixel, and the initial phase of the sampling pixel position to the crest of the input cosine signal were discussed thoroughly in the frequency domain. By introducing the integral function, a general expression of the sampling modulation transfer function was given, and the concept and expression of the average sampling modulation transfer function was proposed. Since that expression eliminates the effect of initial phase, it is much more convenient to the practical applications. For the typical Gaussian spectrum produced by the dispersive spectrometer, the Fourier transform result of that spectrum was multiplied by the average sampling modulation transfer function to produce a functional expression of the modulation transfer function of the whole system. The average aliasing error of the sampling process was expressed as a function of spatial frequencies; the relationship between the peak value of the average aliasing error and the width of the Gaussian spectrum was discussed; and the critical value of the spectrum width to restore this spectrum precisely was proposed. That critical value is significant for providing guidance to the design and fabrication of dispersive spectrometers.

The Effect of the Photoelectric Detector on the Accuracy of the Spectrometer

The Analysis of the Sampling Modulation Transfer Function and the Influence on the Gaussian Spectra

Stray Light And Bandpass Correction In The Spectral Measurement For Light Emitting Diodes

The Influence of Detector Spectral Response on the Peak Position Determination in the Spectrometer Wavelength Calibration Process

Colorimetric and Spectral Characterization of A Color Scanner Using Local Statistics

Discussion of Improving Energy of 4600 Atomic Absorption Spectrophotometer with a Tandem Atomizer

An optimized design method for optical system of a spectroanalyzer

Correcting Thermal-Emission-induced Detector Saturation in Infrared Spectroscopy

An optics-free single-pixel spectrometer using a broadband and tunable dynamic detector

Research status of energy dispersive X-ray fluorescence spectrometer

Photometric Performance of Miniature Spectrometer Based on Linear CCD

CdTe Based Energy Resolving, X-ray Photon Counting Detector Performance Assessment: The Effects of Charge Sharing Correction Algorithm Choice

Ultrahigh-resolution Spectrometer Based on 19 Integrated Gratings

Measurement Precision Improvement for Excimer Laser Pulse Energy Sensor Based on A Special Finite Impulse Response Filter

A High-Performance Spectrometer with Two Spectral Channels Sharing the Same BSI-CMOS Detector.

A method to eliminate the matching problem and improve the spectral property of Talbot spectrometer

Optimization of Sampled Imaging System with Baseband Response Squeeze Model

Random Noise Reduction with More Accurate Calibration for a Spectrometer Using a Two-Dimensional Array Detector

Resolution enhancement by combination of subpixel and deconvolution in miniature spectrometers.

A wavelength calibration process for micro-spectrometers with multichannel detectors - art. no. 68291Q

Beyond spectral resolution in optical sensing: Picometer-level precision with multispectral readout