Abstract:Air-cooled single effect LiBr-H2O absorption chiller has shown advantages in residential solar cooling applications. It can be driven by common non-focusing solar collectors, and save water, maintenance expense and space, due to the absence of cooling tower. However, there is no available small capacity commercial air-cooled LiBr-H2O absorption chiller yet, because of the crystallization risk and difficulty of miniaturization. In this work, a novel air-cooled single effect LiBr-H2O absorption chiller with adiabatic flash evaporator and adiabatic absorber was fabricated and tested. The secondary heat exchanging between refrigerant water and chilled water is avoided by introducing the adiabatic flash process, therefore the conventional chilled water circulation pump and the heat transfer pipes in evaporator are removed. In this way, it is capable of improving the COP and cooling capacity with a lower size and cost of material, as well as less electricity consumption. Furthermore, three sets of experiments were conducted with different operating conditions. The evaporation temperature at 8.6 degrees C can be achieved and it is able to control the indoor air temperature to 26.6 degrees C with a raised evaporation temperature at 14.5 degrees C when the ambient temperature is 35 degrees C. The cooling capacity and COP under low and high ambient temperature are 5.3 kW/0.72 and 4.6 kW/0.65, respectively. When the hot water temperature is raised from 80 degrees C to 90 degrees C, the thermal COP is ranged from 0.76 to 0.64. During the 9 h outdoor experiment, the average thermal COP of this prototype is 0.65. In addition, the average cooling capacity is about 5 kW and the average COPele of this prototype reaches 8.3 during the test.

Discussion on Start-up Mode of LiBr Absorption Chiller

STUDY ON LITHULM-BROMIDE AQUEOUS SOLIYTION AIR-PRECOOLED ADIABATIC ABSORPTION PROCESS

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Dynamic Performance Analysis for an Absorption Chiller under Different Working Conditions

Absorption capability of non-pumped LiBr absorption chiller

Dynamic Modeling and Operation Characteristics Analysis of LiBr Absorption Heat Pump

Theoretical Study of Dual-Heat Mode Operation of Double-Effect Parallel-Flow LiBr-H_2O Absorption Refrigeration System

Experimental study of dynamic behavior on direct-fired lithium bromide absorption unit under non-standard working conditions

REAL OPERATING PERFORMANCE AND ANALYSIS OF GAS-FIRED LITHIUM BROMIDE ABSORPTION CHILLERS

Analysis of the Minimum Activation Temperature of LiBr-H_2O Absorption Chiller

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

NUMERICAL SIMULATION OF INTERMITTENT OPERATION AND STARTUP ON ADSORPTION REFRIGERATION

Experimental investigation on startup of a novel two-phase cooling loop

Influence Study on Chilled Water on the Performance of the Waste Heat Driven Double-effect LiBr Absorption Chiller by Simulation

Dynamic Simulation of Screw Chillers During Start-up

Thermodynamic and Economic Performance Assessment of Double-Effect Absorption Chiller Systems with Series and Parallel Connections

Effects of solution heat exchanger on the performance of absorption chiller

Simulation Study of Gas-Fired Absorption Chiller for Evaluation of Control Strategies

Heat Current Method-Based Modeling and Optimization of the Single Effect Lithium Bromide Absorption Chiller

STUDY ON DIFFERENT PHASE GROUP OPERATION OF ADSORPTION CHILLERS

Experimental Investigation on a Novel Air-Cooled Single Effect LiBr-H2O Absorption Chiller with Adiabatic Flash Evaporator and Adiabatic Absorber for Residential Application