Abstract:Functionally graded materials (FGMs) have broad application prospects owing to their outstanding material properties. In this study, a filtration extrusion device is designed, and low‐content SiC/Al composites are used to explore the feasibility of applying filtration extrusion techniques to the fabrication of FGMs. The results suggest that the extrusion force increases monotonically with an increase in the filtration extrusion ratio. Furthermore, the filtration extrusion process can be divided into two stages based on the change trend of extrusion pressure: at stage 1, extrusion force is small and increases slowly. At stage 2, the extrusion force increases significantly and rapidly. During the filtration extrusion process, the larger the initial content, the lower the extrusion temperature, the smaller the hole‐separation mold area ratio, the faster the increase in the extrusion force, and the greater the maximum extrusion force during the extrusion process. Based on filtration extrusion experiments for various extrusion distances, it is found that the transition from the non‐flow to the flow influence zone is primarily responsible for the enrichment and gradient distribution of SiC particles. The SiC particles are distributed in a gradient, and the content of SiC particles near the separation mold is higher than that on the other side. This article is protected by copyright. All rights reserved.

In-situAl/Mg2Si Functional Graded Materials (fgms) Prepared by Electromagnetic Separation

In-Situ Al/24si Functional Graded Materials Prepared by Electromagnetic Separation

Fabrication of in situ Al/Mg2Si functionally graded materials by electromagnetic separation method

Study on Electromagnetic Force for Preparation of In-Situ Al/Mg 2 Si Functionally Graded Materials by Electromagnetic Separation Method

Study on Hypereutectic Al-Si Functionally Graded Materials by Electromagnetic Separation

Microstructure and Properties of In-Situ Hypereutectic Al-Si Functional Graded Materials

In Situ Multi-Layer Functionally Graded Materials by Electromagnetic Separation Method

Effect of Mg on Nucleation Process of Recrystallization in Al–Mg–Si/SiCp Composite

In-situ Al/Al3Ni functionally graded materials by electromagnetic separation method

Effect of Ti Additions on Structure of In-situ Al∕Si FGMs by Electromagnetic Separation Method

Graded distribution and refinement of Mg<sub>2</sub>Si in Al-Mg<sub>2</sub>Si alloy prepared by traveling magnetic field

Preparation and Mechanical Properties of in Situ Submicron MgAl2O4p/6061Al Composites from Al–Mg–SiO2 System

A comparative study of processing route, microstructures, fracture analysis and phase formation of Al-Si/Mg2Si functionally graded composites: an overview

Fabrication of functionally graded materials from a single material by selective evaporation in electron beam powder bed fusion

Study on in Situ Al-Si Functionally Graded Materials Produced by Traveling Magnetic Field

In situ surface composite and gradient material of Al-Si alloy produced by electromagnetic force

In Situ （mg2si＋mgo）/mg Composites Fabricated from AZ91-Al2（SiO3）3 with Assistance of High-Energy Ultrasonic Field

Effect of synchronous electromagnetic stirring on Laves phase morphology and mechanical property of Inconel625-HSLA steel functionally graded material fabricated by wire arc additive manufacturing

Fabrication of SiC/Al functionally graded materials via filtration extrusion

Microstructure and Mechanical Properties of Mg 2 Si/AZ91 Composites In Situ Synthesized by Using Silica Fume as the Si Source

Preparation of an Mg–Gd–Zn Alloy Semisolid Slurry by Low Frequency Electro-Magnetic Stirring