Abstract:The viscosity of heavy oil is of great importance on crude oil recovery, and the intrinsic relationship between the molecular structure of heavy oil and its viscosity is still unclear. To this end, the chemical structure of heavy oil is characterized by Scanning Electron Microscopy (SEM) and Diffusion-ordered Spectroscopy (DOSY). The relationship between the molecular structure and viscosity of heavy oil is revealed. The morphology of molecular aggregates is dominated by spherical particles, vesicles and films, and the corresponding viscosity increases sequentially. DOSY show that the heavy oil molecules rapidly gathered into aggregates with increasing concentrations. If the saturated aggregation concentration (maximum degree of aggregation) is exceeded, the volume of the single aggregate remains generally fixed but its quantity begins to increase. In addition, the structure-activity relationship between chemical agents and emulsification-stripping, including their mechanism of effect are systematically studied by interfacial tension (IFT), emulsification and micromodel experiments. The results show that the hydrophilic-lipophilic balance (HLB) values of surfactants that stabilize the emulsions are between 13.7 and 14.5. There is no obvious consistency between the emulsification effect of the surfactant and its IFT, and the stripping effect depends on its permeation and wetting action on the solid interface. The formation of emulsions in porous media mainly depends on the rotational disturbance and shear fracture of the displacing fluid, and the wettability of the solid surface determines the peeling rate of the oil film. Comparing with the blockage of large-sized emulsions, the migration of small-sized droplets in the channels as a continuous phase contributes more to the enhanced oil recovery.

STUDY ON CHARACTERIZATION OF HAZE IN ISODEWAXED LUBRICATING BASE OIL

Analysis for Components of a Polishing Wax

Study of Crude Oil Doped with Pour Point Depressant

Compound-Specific Stable Carbon Isotopic Composition Of Petroleum Hydrocarbons As A Tool For Tracing The Source Of Oil Spills

Molecular characterization of polar species in Canadian oil sand bitumens by electrospray ionization and high resolution mass spectrometry

Determination of Wax Deposition Rate Model of Blended Oils with Different Blending Ratios

THE ISODEWAXING TECHNOLOGY OF LUBRICANTS INSIDE AND OUTSIDE CHINA

Characterization of the Precipitation Modes of Paraffin Wax in Water-in-Model-Oil Emulsions

Analysis of the Components of Oil Deodorizer Distillates from Different Origins

INFLUENCE OF AROMATICS CONTENT IN HYDROTREATING FEEDSTOCK ON LUBE BASE OIL QUALITY

Hydrocracking diversity in n-dodecane isomerization on Pt/ZSM-22 and Pt/ZSM-23 catalysts and their catalytic performance for hydrodewaxing of lube base oil

Study on the chemical structure characterization and emulsification-stripping of heavy oil

Investigation on the mechanism of wax deposition inhibition induced by asphaltenes and wax inhibitors

The investigation of flocculation and deposition of heavy components in the crude oil tank based on experiment and molecular simulation

Evaluation and Utilization Optimization of a Deasphalted Oil Hydroisomerization Products Based on Carbon Number Distribution and Hydrocarbon Type Analysis

Study on the Kinetic Process of Asphaltene Precipitation during Crude Oil Mixing and Its Effect on the Wax Behavior of Crude Oil

Mechanistic Study on the Influence of Wax on Hydrate Formation Process

Study on the Dispersancy of Heavy Duty Diesel Engine Oils

In situ probing of wax precipitation of waxy oil using oblique-incidence reflectivity difference at open bulk surface

Study on the effect of wax on hydrate formation in the presence/absence of span80

Effect of Comb-Type Copolymers with Various Pendants on Flow Ability of Heavy Crude Oil