Abstract:A finite element computational methodology is presented for predicting the temperature distribution, fluid flow, and thermal stresses evolving in a solidifying ingot, which itself is growing in length, during the start-up phase of a continuous casting process, with a particular reference to aluminum casting. The approach is based on the coupling of a thermal and flow model with a stress model, The thermal flow model is developed using a deforming finite element method with an Eulerian-Lagrangian transformation to account for the fact that the ingot itself is also growing at a prescribed casting speed. The stress model is developed also by the finite element method, with mechanical deformations in the solidifying materials described by a hypoelastic-viscoplastic constitutive relation. The integrated model has been applied to study the dynamic development of temperature, flow, and stresses in the solidifying ingot during the start-up phase for continuous casting of aluminum. The results show that the fluid flow and temperature distribution experience a rapid change at the initial stage but that the change slows down later in the process as it approaches to the steady state. Computed results compare reasonably well with experimental measurements for temperature distributions in the ingot. It is found that the thermal stresses in general evolve from small to big in magnitude and from compressive to tensile in the solidifying ingot. The hoop stress is larger than other stress components, in particular in the outer surface region. The air gap formed between the ingot and the bottom block increases initially and decreases afterward as a result of stress relaxation.

INFILTRATION OF MOLTEN ALUMINUM WITH TRANSIENT SOLIDIFICATION AND REMELTING IN CENTRIFUGAL CASTING PROCESSES

INFILTRATION AND SOLIDIFICATION/REMELTING OF MOLTEN ALUMINUM IN A CENTRIFUGAL FORCE FIELD

Molten Al Infiltration and Solidification/remelting in a Centrifugal Force Field

Infiltration of Molten Aluminum with Heat Transfer in Circular Pipe by Centrifugal Force

Solidification And Remelting Of Al Through Al2o3 Fibrous Preform Under Centrifugal Force

Flow of Molten Aluminum in Porous Medium during Centrifugal Infiltration Casting Process

Infiltration of molten aluminum and heat transfer in centrifugal casting processes

Solidification and Remelting of Aluminum Though Alumina Preform under a Centrifugal Force Field

Centrifugal Infiltration Process of Fibrous Tubular Preform by Al–Cu Alloy

HEAT TRANSFER OF MOLTEN METAL INFILTRATE THROUGH SiC PREFORM IN CENTRIFUGAL FORCE FIELD

Centrifugal infiltration process of tubular porous preform by a Binary Alloy

Infiltration of Fibrous Preform by Al-Cu Alloy in a Centrifugal Force Field

Effects of Operating Conditions on Infiltration of Molten Aluminum and Heat Transfer in a Centrifugal Force Field

Physical Simulation of Infiltration Flow During Centrifugal Casting Titanium Alloy Melts Feeding

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

Molten Filling in Vertical Centrifugal Casting and Its Numerical Simulation

Investigation on the Kinetics of Infiltration of Liquid Aluminium into an Alumina Fibrous Preform

Infiltration flux and similarity criterion during centrifugal casting titanium alloy melts feeding

Numerical simulation of melt mold filling during centrifugal casting of Ti Alloy casting

Experimental and numerical studies on the influence of centrifugal casting parameters on the solidification structure of Al-Cu alloy

Physical simulation similar theory and experiment during centrifugal casting Ti alloy melts filling flow