Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Gas phase selective catalytic oxidation of toluene to benzaldehyde on V2O5-Ag2O/η-Al2 O3 catalyst

Surface Acidic and Redox Properties of V–Ag–O/TiO 2 Catalysts for the Selective Oxidation of Toluene to Benzaldehyde

Tuning the oxygen vacancy and acidity of V-Ag-Ce/TiO 2 catalyst for selective gas-phase oxidation of toluene to benzaldehyde

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Surface acidic and redox properties of V-Ag-Ni-O catalysts for the selective oxidation of toluene to benzaldehyde

Advances in Development of Vapor Phase Selective Oxidation of Toluene to Benzaldehyde

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Selective Oxidation of Toluene Using Surface-Modified Vanadium Oxide Nanobelts

Selective solvent-free oxidation of toluene to benzaldehyde over zeolite supported iron

VMoNb/CeO 2 as an efficient catalyst for the gas-phase selective oxidation of toluene to benzaldehyde

Highly efficient selective oxidation of toluene to benzaldehyde over Cu-V oxides supported on amorphous SiO2

Catalytic Oxidation of 1,2-Dcbz over V2O5/TiO2-CNTs: Effect of CNT Diameter and Surface Functional Groups.

Electrocatalytic oxidation of toluene into benzaldehyde based on molecular oxygen activation over oxygen vacancy of heteropoly acid

Catalytic conversion of 1,2-dichlorobenzene (1,2-DCBz) over V2O5/TiO2-based catalysts

Operando Raman-online FTIR Investigation of Ceria, Vanadia/ceria and Gold/ceria Catalysts for Toluene Elimination

Novel Vanadia/meso-Co3O4 catalysts for the conversion of benzene-toluene-xylene to environmental friendly components via catalytic oxidation

Enhancing catalytic oxidation of toluene over Ag/Co3O4 by regulating Ag-Co interaction

V–O–Ag Linkages in VAgO x Mixed Oxides for the Selective Oxidation of p -Xylene to p -Methyl Benzaldehyde

Selective liquid phase oxidation of toluene with air

Facile hydrothermal synthesis of VO2 nanosheets as robust catalysts for liquid-phase selective oxidation of benzyl alcohol under atmospheric O2

Catalytic oxidation of toluene using a facile synthesized Ag nanoparticle supported on UiO-66 derivative