Abstract:Bifunctional initiators with two labile groups ( e g peroxides or azo groups) are frequently used in the polymer industry for the synthesis of vinyl polymers and resin curing In general, there are two types of bifunctional initiators: one is symmetrical bifunctional initiators containing two labile groups of equal structure, the other is unsymmetrical bifunctional initiators containing two labile groups of unequal structure One of the potential advantages of using bifunctional initiators is that high polymer molecular mass and high polymerization rate can be obtained simultaneously by controlling the initiator decomposition rate through optimal reaction temperature programming For free radical polymerization of methyl methacrylate (MMA) with monofunctional initiators, the kinetics is reasonably well understood in both low and high monomer conversion regimes However, the presence of an additional labile group in bifunctional initiators makes the polymerization kinetics very complicated. This is because labile groups such as peroxides become redistributed repeatedly in the growing and inactive polymers and they are engaged in further initiation, propagation, chain transfer and termination reactions during the course of polymerization. The effects of temperature and initiator concentration on the kinetics of MMA bulk polymerization initiated by 2,5 dimethyl 2,5 bis(2 ethyl hexanoyl peroxide) hexane (TX 141) were investigated.The energy of activation of MMA bulk polymerization initiated by TX 141 was about 91 kJ·mol -1 , and that of TX 141 decomposition was about 140 kJ·mol -1 , which was more close to the experimental data.The reaction order of TX 141 concentration was about 0 72,because there was mono and bi molecule termination. The kinetic comparison initiated by TX 141 and benzoyl peroxide (BPO) with the same half life period showed that the kinetics was the same when the concentration of TX 141 was half of that of BPO.But, the number average molecular mass ratio of that initiated by TX 141 to that by BPO was from 1 2 to 1 33 increasing with the conversion.There was an exothermal peak in the DSC curve of polymer initiated by TX 141 at low conversion, but there was no peak at high conversion and no peak was observed for the polymer initiated by BPO.It was shown that the two functional groups of bifunctional initiator decomposed at different times during the polymerization process.

Decomposition Mechanism of 3, 6, 9-Triethyl-3, 6, 9-Trimethyl-1, 4, 7-Triperoxonane and Its Behavior in the Styrene Bulk Polymerization

Alkyl Halide/tertiary Amine As Novel Initiators for Free Radical Polymerizations of Methyl Methacrylate, Methyl Acrylate and Styrene

Ethylene polymerization by diphenyl ether bridged dinuclear titanocenes/MAO

Synthesis and characterization of block copolymer with cyclic triperoxonane

KINETICS OF STYRENE POLYMERIZATION INITIATED BY DIFUNCTIONAL INITIATOR

THE PREPARATION OF MMT-SUPPORTED INITIATOR AND ITS APPLICATION IN THE EMULSION POLYMERIZATION OF STYRENE

TiCl4 Immobilized on a Composite Support SiO2/MgCl2·x(1,4‐butanediol)/poly[styrene‐co‐(acrylic Acid)] for Ethylene Polymerization: the Barrier Effect of Poly[styrene‐co‐(acrylic Acid)]

Free‐radical Bulk Polymerization of Styrene with a New Trifunctional Cyclic Peroxide Initiator

Styrene polymerization with ternary neodymium-based catalyst system: effects of catalyst preparation procedures

Decomposition of 2,5-Dimethyl-2,5-di(2-ethylhexanoylperoxy)hexane and Its Use in Polymerization of Styrene and Methyl Methacrylate

Kinetics of Styrene Polymerization Using a Novel Initiator

Experiment and Simulation on Styrene Polymerization with Linear Bifunctional Initiator 2,5-Dimethyl-2,5-di(2-ethylhexoylperoxy)hexane (Dmdehph)

Kinetics of methyl methacrylate polymerization initiated by bifunctional initiator

Reverse Atom Transfer Radical Polymerization Of Styrene Using Bpo As The Initiator Under Heterogeneous Conditions

Synthesis of PSt-TMI Copolymer and Studies of the Copolymerization Kinetics

Investigation of Pyrolysis Kinetics, Mechanism and Thermal Stability of Tert-Butyl Peroxy-2-ethyl Hexanoate

Synthesis and Characterization of Polystyrene Initiated Using Polymeric Peroxide

Atom Transfer Radical Polymerization of Styrene with 2‐(1‐bromoethyl)‐anthraquinone As an Initiator

Thermal hazard analysis of the dual initiator-initiated styrene polymerisation with ethylbenzene as diluent

Atom Transfer Radical Polymerizations of Styrene and Butadiene As Well As Their Copolymerization Initiated by Benzyl Chloride / 1-Octanol-substituted MoCl5 / PPh3

Radical Polymerization of Styrene Mediated by 9-(1-Phenylethyl)-9-((1-phenylethyl)thio)-9h-thioxanthene