Abstract:Currently eutrophication has become a hot issue all over the world.The removal of phosphorus from wastewaters is regarded as an important approach to fight eutrophication since phosphorus is one of the main factors causing eutrophication.The chemical phosphorus removal technology with ferric salt as a precipitant is in widespread use to meet the wastewater discharge standard.The optimization of phosphorus removal technology helps to cut down the cost of wastewater treatment.Herein the response surface methodology(RSM)is introduced to investigate the individual and combined effects of operation parameters.The performance of chemical phosphorus removal technology with ferric salt as a precipitant is dependant on a series of factors.Fe/P ratio,pH and flash mixing speed(FMS)were chosen as objects of study,and single-factor experiment and multiple-factor experiment were carried out to optimize the phosphorus removal efficiency.The results of single-factor experiment showed that both Fe/P ratio and pH had significant effects on phosphorus removal,but FMS did not.When the phosphorus concentration was 100mg/L,the optimal operation parameters were Fe/P ratio 3.0,pH 8.0,FMS 175-225r/min.The results of multiple-factor experiment showed that the individual effects of operation parameters on phosphorus removal were in order as Fe/PpH FMS.The combined effects of operation parameters were in order as Fe/P-FMS pH-FMS Fe/P-pH,among which the effects of Fe/P-FMS and Fe/P-pH were positive and the effect of pH-FMS was negative.Based on the experiment,priority/combinationmodel was proposed to enhance the phosphorus removal with ferric salt as a precipitant.The optimal operation parameters were as follows:Fe/P=2.57,pH=6.31and FMS=136r/min,when the phosphorus concentration was 100mg/L.Both synthetic and real wastewaters were used to verify the feasibility ofpriority/combinationmodel.Operated according to the model,the phosphorus removal was larger than 97%and the fractional error was less than 3%.It can be concluded that the response surface methodology is feasible for the optimization of operation parameters in wastewater treatment processes.Thepriority/combinationmodel is effective for the improvement of phosphorus removal from wastewaters with ferric salt as a precipitant.During the wastewater treatment,the synergic action of operation parameters should be fully used,while the antagonistic action of operation parameters should be carefully avoided.

Efficiency of CFPS enhanced coagulation in iron and steel wastewater treatment

Landfill Leachate Pretreatment by Coagulation–flocculation Process Using Iron-Based Coagulants: Optimization by Response Surface Methodology

A Comparative Study Of Conventional Coagulation And Sludge Recycling Enhanced Coagulation For Low-Turbidity Source Water: The Effect And Applicability

Preparation of poly ferric sulfate and the application in micro-polluted raw water treatment

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Phosphorus Removal Using Ferric–calcium Complex As Precipitant: Parameters Optimization and Phosphorus-Recycling Potential

Research on Treatment of Nickel-containing Waste Water with Polymeric Ferric Phosphoric Sulfate

Study on the pretreatment of printing & dyeing wastewater with composite polyaluminum ferric flocculants

Study on the preparation of polysilicate ferric flocculant and its treatment of high turbidity tailings water

Process Optimization for Phosphorus Removal with Ferric Salt by Response Surface Methodology

Application of a Novel Strategy—advanced Fenton-chemical Precipitation to the Treatment of Strong Stability Chelated Heavy Metal Containing Wastewater

Study on removal of phosphorus and COD in wastewater by sinusoidal AC Fenton oxidation-coagulation

An enhanced coagulation using ferric chloride and poly-ferric chloride coagulant assisted by polyamidine: Performance and mechanisms

Comparative Study on the Removal Rate of CODcr with Three Kinds of Coagulants

Experimental study on the treatment of high COD metal degreasing cleaning wastewater by coagulation and two-stage Fenton oxidation

Disintegration of waste activated sludge with composite ferrate solution: Sludge reduction and settleability

Electroplating Wastewater Treatment by Polyaluminum Ferric Chloride

Performance evaluation of Fe-based water treatment sludge for dewatering of iron ore tailings slurry using coagulation-flocculation process: Optimization through response surface methodology

Multiple Response Optimization of the Coagulation Process for Upgrading the Quality of Effluent from Municipal Wastewater Treatment Plant

Enhanced Coagulation-Flocculation Performance of Iron-Based Coagulants: Effects of PO4(3-) and SiO3(2-) Modifiers

Study on preparation,characterization and application of nano-sized polyferric sulfate coagulant