Abstract:In this work, a detailed study on the number of exhaust particles, the particle size distribution and the geometric mean diameter from a 1.5 l gasoline direct-injection engine running with different engine operating parameters was conducted. The air-to-fuel ratio, the spark timing, the injection timing and the exhaust gas recirculation rate were varied at the same engine speed and the same engine load in order to understand how the mixture condition before ignition and the oxygen concentration affect the particulate matter emissions in terms of the total number and the size distribution. The experimental results showed that a lean mixture can significantly reduce the total number of particles by up to 90% compared with the rich mixture condition. When a lean mixture was used, most of the particulate matter was in the nucleation mode. The higher air-to-fuel ratio may have enhanced the oxidation of particles in the combustion process. Delaying the spark timing can also reduce the particulate matter emissions, especially for nucleation-mode particles which decreased by up to 65.41% compared with those for the early-spark-timing condition. The lower in-cylinder temperature may have resulted in the formation of a reduced number of nucleation-mode particles. The injection timing affected both the mixing process and the heat release process and could be optimized to reduce the particulate matter emissions. For a brake mean effective pressure of 3 bar, advanced injection timing reduced the numbers of particles in both the nucleation mode and the accumulation mode. The longer mixing duration improved the mixture homogeneity and led to lower formation rates of particles. Increasing the exhaust gas recirculation rate was effective in reducing the accumulation-mode particle emissions, while increasing the nucleation-mode particle emissions.

Characteristics of Particulate Emissions Fueled with LPG and Gasoline in a Small SI Engine

Study of the Timing on Characteristics of Particulate Emissions for LPG and Gasoline Fuels

Characteristics of Particulate Emissions at Idle from a Small LPG EFI SI Engines

Experimental Study on the Particulate Matter Emission Characteristics for A Direct-Injection Gasoline Engine

Experimental Investigation on Liquefied Petroleum Gas Engine

An Experimental Research on the NOx Emissions of the 492Q Gasoline Engine Using LPG

Experimental Study on Emission of LPG Engine and Vehicle with Electronic Multi-point Continuous Injection System

Individual particles emitted from gasoline engines: Impact of engine types, engine loads and fuel components

Emission Behavior of a Small LPG Engine Equipped with a Proportional Mixer

THE STUDY OF APPLICATION OF LIQUEFIED PETROLEUM GAS TO GASOLINE ENGINES

Experimental Studies on the Combustion Characteristics and Performance of a Naturally Aspirated, Direct Injection Engine Fuelled with a Liquid Petroleum Gas/diesel Blend

Research and Experiments about Using LPG as Substitute Fuel on Mini Gasoline Engine

Particle Number and Size Distributions from Gasoline Engine

Optimization and Lean Burn of LPG for Small SI Engine

Size Distribution of Particles Emitted from Liquefied Natural Gas Fueled Engine

Particulate Emissions from Gasoline Vehicles Using Three Different Fuel Injection Technologies

Experimental Study on Intake Liquid Injection of LPG-Fueled Engine

Experimental study on a LPG engine equipped with electronic control device

The Study of Motorcycle Engine based on Electronic Controlled Liquefied Petroleum Gas Injection

Effect of the Diesel Injection Timing and the Pilot Quantity on the Combustion Characteristics and the Fine-Particle Emissions in a Micro-Diesel Pilot-Ignited Natural-Gas Engine

Study on LPG Engine of Motorcycle