Abstract:This paper presents a numerical investigation into the bending behaviour of uncorroded and corroded reinforced concrete (RC) continuous beams with a strengthening system. Finite element analysis (FEA) was performed on ten RC beams considering interface performance, including five uncorroded and five corroded beams. The cracks development, bending capacities and load-displacement curves of the simulated RC beams in the loading process were validated against those from tests. Then, a parametric study including 35 RC beam models, considering the effects of carbon-fabric (CF) mesh layer, complete wrapping layer and the degree of corrosion of steel bar on their bending capacities, was conducted. Ductility and strengthening effects of specimens were discussed in the parametric study. It can be found that the carbon-fabric reinforced cementitious matrix (C-FRCM) strengthening system can improve the bending capacities of the corroded RC beams. As the layer of CF mesh increases, the ductility of the specimen decreases. The combined use of the C-FRCM plate and the complete wrapping as the end anchorage enhanced the ultimate loads of RC beams to a greater extent than those strengthened with C-FRCM plate only. The applicability of current design codes for RC beams with C-FRCM strengthening system was examined through comparisons of the bending capacity predictions of RC beams with those obtained from tests and numerical analyses. It was found that European Code (FIB Bulletin 14) provides more accurate predictions than American Specifications (ACI 549.4R-20, AC 434-0616-R1, ACI 440.2R-17) and Chinese Code (CECS 146-2003 (2007)). Therefore, design modifications based on the most accurate design rule of FIB Bulletin 14 were made. By utilizing regression analysis on the numerical results, the formula for bending capacities of the examined RC beams was proposed and showed improved accuracy.

Calculation of Bearing Capacity of RC Member in Bending with FRP Reinforcement

Test on Flexural Performance of RC Bridge Member after Overload Reinforced with Externally Bonded FRP

Experimental Study on CFNRST Members under Combined Compression and Bending

Predicting deflection of retrofitted reinforced concrete beams

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Calculation of Bending Capacity of Wood Beam Reinforced with FRP

Analysis and Calculation of Flexural Strength of RC Members Strengthened with CFRP Sheet

A New Flexural Strength Model of CFRP-strengthened RC Beams with Intermediate Crack Induced Debonding Failure

RESEARCH ON FLEXURAL BEHAVIOR OF RC BEAMS STRENGTHENED WITH BASALT FIBER REINFORCED POLYMER

A PRACTICAL METHOD OF ULTIMATE FLEXURAL CAPACITY OF RC BEAMS STRENGTHENED WITH CFRP PLATES

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Experimental Study of Flexural Behavior of RC Beams Strengthening with BFRP Sheets

Study on Flexural Behavior of Timber Beams Strengthened with FRP

Analysis and calculating method of flexural capacity of RC T-beams strengthened with prestressed CFRP sheets

Bending Behaviour of Corroded RC Continuous Beams with C-FRCM Strengthening System

Flexural property and design method evaluation of BFRP and steel bars hybrid reinforced concrete beams

Practical Design Approach for Calculating Flexural Capacity of Steel Reinforced Ultra-high Toughness Cementitious Composite Bending Beams

The simplified calculation for flexural bearing capacity of RC beams strengthened with carbon fiber sheets

Experimental investigation and numerical analysis of RC beams shear strengthened with FRP/ECC composite layer

The Experiment of Ultimate Capacity for the Reinforced Concrete Beam Strengthened with Cfrp