Abstract:Pellet quality is one of the key technologies restricting the smelting of high proportion pellets in the blast furnace, especially the reduction swelling index of low silicon fluxed pellets. In this paper, the inhibition effect of grinding blast furnace return ore on the reduction swelling index of low silicon fluxed pellets was studied and application has been conducted in Shougang Jingtang Company. The experimental results show that the addition of 5–15% fine grinding blast furnace ore into pellet production significantly reduced the reduction swelling index of pellets from 23.5% to 14.3%. Microstructure and energy spectrum analysis shows that calcium ferrite, magnesium ferrite and liquid phase in the pellets with fine grinding blast furnace return ore increased obviously with a more uniform distributed liquid phase between hematite particles than in the basic group pellets and tended to be "homogenized". It is conducive to inhibiting the generation of ferric whiskers in the reduction process of the hematite phase, and thus contributes to the reduction of the swelling index. Since its implementation at Shougang Jingtang in 2020, this technology has yielded positive results. The fluxed pellets exhibit good quality with an alkalinity of 1.1, a SiO 2 content of 2.1%, and a reduction in the swelling index from 18.1% to 16.5%. Besides, the pellet ratio into blast furnace has reached 55%, the cumulative average utilization coefficient of three 5500 m 3 super-large blast furnaces is 2.43t/(m 3. d), and the monthly average for a single furnace reaches 2.62t/(m 3. d). Meanwhile, consumption reduction of calcium-containing flux slaked lime in fluxed pellets by 0.9% is greatly beneficial to reducing the cost of pellets and expanding the resources of pellet powder.

Experimental Study on Improving Quality of Sintered Ore by Adding Boric Acid

EXPERIMENT STUDY ON THE EFFECT OF IRON ORE SINTER BEHAVIOR WITH ADDING BIOMASS

Relationship and Mechanism Analysis of Soft-Melt Dropping Properties and Primary-Slag Formation Behaviors of the Mixed Burden in Increasing Lump Ore Ratio

Study on Influencing Factors of High-Temperature Basic Characteristics of Iron Ore Powder and Optimization of Ore Blending

Experimental Study on Effect of Flux Addition on the Sintering Harmful Gas Emission

Sintering test research with addition of hematite concentrate

Study on Optimizing the Sintering Proportioning in Masteel

Investigating the Effect of the Iron Ore Pellet Addition on the Interaction Among Blast Furnace Burden in the Cohesive Zone

Influence of Vanadium–Titanium Sinter Basicity on Cohesive Dripping Properties of Blast Furnace Comprehensive Burden

Effect of diboron trioxide on the crushing strength and smelting mechanism of high-chromium vanadium–titanium magnetite pellets

Mechanism of Strength Improvement of Magnetite Pellet by Adding Boron-bearing Iron Concentrate

Effect of B2O3 on the Melting Characteristics and Slag-Matte Separation of Nickel Flash Furnace Melting

Research on influence of grinding blast furnace return ore on reduction swelling index of low silicon fluxed pellets and production practice

Effect of Ca-Fe oxides additives on NOx reduction in iron ore sintering

Effect of Cooling Methods on the Strength of Silico-ferrite of Calcium and Aluminum of Iron Ore Sinter During the Cooling Process

Effect of manganese ore and basicity on the consolidation characteristic of nickel‐chromium iron ore pellets

Experimental Investigation and Numerical Modeling of Strength Properties of Iron Ore Sinter Based on Pilot-Scale Pot Tests and X-ray Computed Tomography

Research on Dezincification of Ironmaking and Steelmaking Ashes

Effect of B 2 O 3 on the Structure and Viscous Behavior of Ti-Bearing Blast Furnace Slags

Effect of Basicity on the Reduction Swelling Performance of Pellets Prepared from Bayan Obo Iron Ore Concentrate Based on Microscopic Characterization

Experimental Study On Crushing Strength And Young'S Modulus Of Granules In Iron Ore Sintering Using Taguchi Method