Abstract:The pressure drop characteristics of steam-water two-phase flow at a low mass velocity in a four-head rifled tube were experimentally studied under an adiabatic condition with pressure ranging from 11.3 to 21.5 MPa, mass velocity ranging from 250 to 1200 kg/m(2) s, and steam quality ranging from 0 to 1. A test section composed of a 2000 mm long horizontal tube and 3500 mm long vertical tube was set up to fully evaluate the pressure drop characteristics, including the gravitational pressure drop and frictional pressure drop. It was found that the self-compensating characteristic is present in the four-head rifled tube when the mass velocity is lower than a certain critical value. The major parameters affecting the two-phase multiplier are pressure and steam quality. The two-phase multiplier increases with increasing steam quality and decreases with increasing pressure. In the near-critical pressure region, the two-phase frictional pressure drop approaches that of single phase flow because the density difference between water and steam is small. A new correlation for the two-phase multiplier for the frictional pressure drop of steam-water two-phase flow in the four-head rifled tube was proposed based on a total of 516 experimental data points, with a root mean square error of less than 20%. Comparing these results with previous correlations, the two-phase frictional pressure drop in the rifled tube is lower than those studied by previous scholars under low-velocity conditions, especially in the high steam quality region. The results provide instructive guidelines to improve the design and operational safety of a supercritical circulating fluidized bed boiler. (C) 2017 Elsevier Ltd. All rights reserved.

Research on the Pressure-lifting Performance Calculation Model of Supersonic Steam-Water Two-Phase Flow in Channel of Variable Section

Experimental Research on Performance of Supersonic Steam-Driven Jet Injector and Pressure of Supersonic Steam Jet in Water

The Preference of Steam-water Two-phase Flow Direct Contact Pressure-lifting Heater

Research on the Performance of Steam-Water Two-Phase Flow Shock Wave Injector

Research on Mechanism of Steam-Water Two-Phase Flow Injector

Experimental study on a steam-driven turbulent jet in subcooled water

Exploration on Method of Simulation and Modeling for High-Velocity Steam-Solid Two-Phase Flow in Supernormal Parameters

Numerical Analysis on Pressure Distribution for Sonic Steam Jet Condensed into Subcooled Water

Experimental Research on Temperature Difference between two Phase Flow in Steam Injector

Flow Characteristic of Steam Jet Condensed into a Water Pipe Flow - a Numerical Study

The Numerical Calculation of Two-Phase Pressure Drop During Flow Boiling in the Vertical Annular Channel

Research on the steam plume shape and pressure fields of supersonic steam jet in subcooled water

Numerical Investigation on the Effects of Steam and Water Parameters on Steam Jet Condensation Through a Double-Hole Nozzle

Research on flow and heat transfer characteristic of over-expanded supersonic steam jet in water

Theoretical Study on Predicting the Performance of Steam Ejector by Analogy Method

Experimental Study on the Pressure Drop Characteristics of Steam-Water Two-Phase Flow at a Low Mass Velocity in a Four-Head Rifled Tube

Research on the Characteristicof Second Dominant Frequency of Pressure Oscillation for Supersonic Steam Jet

Numerical Simulation on Pressure Drops for Air-Water Two-Phase Flow in Micro-Channels

Water-flow Simulation and CFD Research on Supersonic Flow Phenomenon

Research on Performance Improvemont of Steam Injector Used in Heating System

Numerical Study of the Effct of Nozzle Configuration on Supersonic Condensation Jet