Abstract:We present three-dimensional simulations of the image formation of microstructure in near-field optical microscopy with the three-dimensional finite-difference time-domain method (FDTD). First, we calculated the intensity distributions inside and outside and the flux densities for both the tapered and parabolic fiber probes used in near-field optical microscope and nanolithography. The calculating result shows that for different kinds of shape the intensity distributions in both probes are similar and present standing wave forms; but the amplitudes and locations of peaks of the standing waves are different from each other. The intensity outward parabolic probe is higher than that outward tapered probe. Then we computed the intensity distributions of the samples which are composed of different materials by different polarization illumination. Assuming an aperture-type probe in collection-mode near-field microscope, we compare the images produced from the sample composed of three dielectric blocks in nanometer at a distance of 25nm and 150nm, respectively, under constant-high-scanning mode along with the direction of the polarization of the illuminating light, with near-field distribution of the sample without probe. The results show that the probe disturbs the original field distribution of the sample. The received signal is different from the original field distribution of the sample. However the received signal contains high frequency information of the sample in near-field region. Due to probe-sample interaction, parts of evanescent field transform into propagation wave. Only the interaction between the probe and sample in the near field makes possible to probe the high-frequency components and achieve the super-resolution. Therefore, the detected resolution depends on an assembly of the tip size, shape of the tip, distance between tip and sample, relative position and material characteristics of both tip and sample. These results provide the basis for correct interpretation of experimental work.

Near-field optical virtual probe based on SIL for optical data storage

Experimental research on near-field optical storage and virtual probe based on solid immersion lens

Near-Field Optical Virtual Probe: A Potential Method For Near-Field Storage

Numerical and Experimental Research on the Near-Field Optical Virtual Probe

A Virtual Optical Probe Based on Evanescent Wave Interference

Numerical Simulation Analysis of A Near-Field Optical Virtual Probe

Numerical Simulation of Evanescent Bessel Beams and Apodization of Evanescent Field in Near-Field Optical Virtual Probe

Near-field optical recording based on solid immersion lens system

Near-field to far-field subwavelength imaging using Non-radiative Dielectric Waveguide probe

Experimental Research on Focusing Property of Radially Polarized Beam Based on Solid Immersion Lens

Study on Near-Field Optical Imaging Mechanism

Numerical Simulation of Electromagnetic Propagation in Super-Resolution Near-Field Structure

Development of real-time method to measure SIL-DISK spacing for super-low-flying system

Numerical Simulation Analysis of an Optical Virtual Probe Based on Surface Plasmon Polaritonic Band-gap Structures

Study on the Field Distribution of the Probes in Scanning Near-Field Optical Microscope Using Finite-Difference Time-Domain Calculations

Computational Diffraction-Limited Imaging with a Non-Imaging Spatial Information Transfer Lens

Near-Field Optical Storage System Using A Solid Immersion Lens With A Left-Handed Material Slab

Research on the Design of an Optical Information Storage Sensing System Using a Diffractive Optical Element.

Detection of optical field by near-field scanning optical microscopy

Development and Application of Near-Field Optical Microscopy

Development of optical fiber probe for the scanning near-field optical microscope