Abstract:International Journal of Engine Research, Ahead of Print. Powertrain electrification is currently considered a promising solution to meet the challenge of CO2 reduction requested by future emission regulations for the automotive industry. Despite the potential of full electric powertrains, such as Battery Electric Vehicles (BEVs) and Fuel Cell Electric Vehicles (FCEVs), their diffusion has been severely limited by various technological aspects, market drivers and policies. In this scenario, there is a growing interest in Hybrid Electric Vehicles (HEVs) powered by spark-ignited Dedicated Hybrid Engines (DHEs), mainly because of their high efficiency and very-low pollutants. However, since DHEs are usually operated at relatively high loads, with advanced combustions and high in-cylinder pressure and temperature peaks, reliability over time becomes a crucial aspect to be guaranteed by the engine management systems. This work presents development and validation of an innovative control-oriented model, suitable to predict the maximum in-cylinder pressure of SI engines. The procedure is based on information that can be measured or estimated, in real time, on-board a vehicle, and the computational cost is compatible with modern engine control units. To verify accuracy and robustness of the methodology, two different SI engines have been analyzed over their whole operating range: a turbocharged Gasoline Direct Injection (GDI) engine and a Naturally Aspirated (NA) engine. After calibrating the model parameters using both average and cycle-by-cycle data, the accuracy of the maximum in-cylinder pressure estimation has been evaluated always returning errors lower than 3% between measured and estimated maximum in-cylinder pressure.

Cylinder Pressure Estimation for Engines Using Second-Order Sliding Modes

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Impact of the Piston Secondary Motion on Its Slap Force

A Research on Engine Phase and Speed Estimation Method Based on Cylinder Pressure Sensor

A research on cylinder pressure sensor as an alternative for the camshaft and crankshaft position sensors of engine

In-Cylinder Pressure Estimation from Rotational Speed Measurements via Extended Kalman Filter

Research on On-line Estimation of Engine Indicated Mean Pressure

A Control-Oriented Engine Torque Online Estimation Approach for Gasoline Engines Based on In-Cycle Crankshaft Speed Dynamics

Recursive Engine In-Cylinder Pressure Reconstruction Using Sensor-Fused Engine Speed

Real-time misfire detection via sliding mode observer

A novel method for in-cylinder pressure prediction using the engine instantaneous crankshaft torque

The Piston Slap Force Reconstruction of Diesel Engine Using WOA-VMD and Deconvolution

A Deep Learning Approach to Predict In-Cylinder Pressure of a Compression Ignition Engine

Soc Detection of Diesel Engines Based on Online Estimation of Motored Pressure

On-line Performance Supervision and Fault Diagnosis for Automotive Engines Using Sliding Mode Tracking Control

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

In-Cylinder Pressure-Based Low-Pressure-Cooled Exhaust Gas Recirculation Estimation Methods for Turbocharged Gasoline Direct Injection Engines

Cylinder Pressure and Combustion Noise of Internal Combustion Engine

Analysis Of Structural Dynamic Response Of Multi-Cylinder Internal Combustion Engine Block Under The Excitation Of Piston Thrust Forces

Development of a control-oriented physical model for cylinder pressure peak estimation in SI engines

Application of non-linear observers to on-line estimation of indicated torque in automotive engines