Abstract:The internal combustion engine will continue to be the primary source of power for transportation. Spark ignition (SI) engines are still widely used for mobility due to their wide range of operating conditions. The key operating variables of an engine are primarily controlled by an engine control unit that has been calibrated. However, a less accurate sensor can lead to large variations in engine performance and emissions. The purpose of this study was to investigate the importance of air-fuel ratio sensor precision during operation of various engines. In this study, a one-dimensional (1D) computational fluid dynamics (CFD) model was used to analyze the engine response due to the variation of the equivalence ratio sensor precision at different engine speeds and loads, to explore the main indicators influenced by the precision of equivalence ratio measurements, and to propose a discriminant criterion for evaluating the suitability of the proposed equivalence ratio precision in relation to the conversion rate of three-way catalyst and vehicle emissions. The results show that for engine performance, it varies slightly with small changes in the fuel-to-air ratio. At higher engine speeds, a slight change in the air-fuel ratio leads to a smaller change in emissions. At the same time, changes in fuel-to-air ratio have a significant effect on carbon monoxide (CO) and nitrogen oxides (NOx) emissions. Carbon monoxide is the most sensitive to the air-fuel ratio, followed by nitrogen oxides, while unburned hydrocarbons are not sensitive to it. And for the three measurement accuracies studied in this paper (0.5%, 1%, and 2%), the accuracies are acceptable, but combining the relative errors of the actual emissions of CO and in order to achieve accurate combustion control, it is recommended that the sensor accuracy should be at least higher than 1% for the port fuel injected engine investigated in this study.

Research on On-line Estimation of Engine Indicated Mean Pressure

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Improving Machine Learning Model Performance in Predicting the Indicated Mean Effective Pressure of a Natural Gas Engine

A Research on Engine Phase and Speed Estimation Method Based on Cylinder Pressure Sensor

Online measurement of piston-assembly friction with wireless IMEP method under fired conditions and comparison with numerical analysis

Research Of Measuring Method On The On-Line Output-Of Concrete Pump

Cylinder Pressure Estimation for Engines Using Second-Order Sliding Modes

A research on cylinder pressure sensor as an alternative for the camshaft and crankshaft position sensors of engine

Development of indicator diagram measurement system for high speed gasoline engines

On-board Torque Estimation Base on Mean Value SI Engine Models

In-Cylinder Pressure Estimation from Rotational Speed Measurements via Extended Kalman Filter

A Control-Oriented Engine Torque Online Estimation Approach for Gasoline Engines Based on In-Cycle Crankshaft Speed Dynamics

Soc Detection of Diesel Engines Based on Online Estimation of Motored Pressure

Numerical Investigation on the Indicated Mean Effective Pressure and Integral Heat Release Rate Variations under Different Key Operating Parameters of a Spark‐Ignited Free Piston Engine Generator

A novel method for in-cylinder pressure prediction using the engine instantaneous crankshaft torque

An improved technique for measuring piston-assembly friction and comparative analysis with numerical simulations: Under motored condition

Development of a control-oriented physical model for cylinder pressure peak estimation in SI engines

Recursive Engine In-Cylinder Pressure Reconstruction Using Sensor-Fused Engine Speed

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

An Improved Method to Estimate Initial Rotor Position for Surface-Mounted Permanent Magnet Synchronous Motors

Robust Instant Angle Speed Measurement for Internal Combustion Engines-A Novel Sensing Suite and Methodology