Abstract:The intake duct is an important component of waterjet propulsion system and its hydraulic performance is directly connected with the capability of the waterjet pump and even the propulsion performance of the system. In order to optimize the flush-type intake duct, the present paper proposes a multi-objective optimization system including Design of Experiments (DOE), Computational Fluid Dynamics (CFD), three-dimensional parametric design, approximate model, the modified Non-dominated Sorting Genetic Algorithm-II (NSGA-II) and a Technique for Ordering Preferences by Similarity to Ideal Solution (TOPSIS). The nonuniformity and perpendicularity of outflow, and hydraulic efficiency for the intake duct are treated as the optimization objectives with four geometrical parameters as the design variables. Local sensitivity analyses indicate that the optimization objectives are significantly affected by the inclination angle and slightly affected by the lip vertical distance of the intake duct. During IVR = 0.3-0.8, the outflow quality and hydraulic efficiency of the optimised intake duct are greatly improved. The nonuniformity after optimization decreases by 27.8% and perpendicularity increases by 3.07% at the design condition of IVR = 0.7 and V-s = 19.49 m/s. Based on the flow at the outlet plane of intake duct, the pressure distribution after optimization is very uniform and the tangential velocity is small without obvious secondary flow. During the application to a mixed-flow waterjet propulsion system at various navigation speeds, the nonuniformity of the optimized intake duct decreases by 20.4% and perpendicularity increases by 4.11% on average, demonstrating that the optimized intake duct performs a better outflow quality. It is also noted that the non-uniform flow from the intake duct mainly affects pressure distribution on the suction surface of impeller blade and causes different shaft power.

Optimization Design of Water-Jet Propulsion System Use in Amphibious Vehicles

Working Characteristics Analysis of Waterjet Propulsion for Underwater Vehicles

Design Method of Water Jet Pump Towards High Cavitation Performances

Numerical analysis of a waterjet propulsion systerm's adaptability on the condition of shallow water

Working characteristic analysis of waterjet propulsion for underwater vehicle

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

Design Method for Low Specific Speed Axial Flow Pump for High-Speed Undersea Vehicles

Research on Configuration and Performance of Water Ramjet Pressurized Water Intake System

Optimization method investigation for centrifugal pump performance based on 3D inviscid inverse design

Research on hydraulic optimization design method of water-jet propulsion pump considering hump index

Research on optimisation design of cavitation noise of pump-jet propulsion

Analysis of Construction Principle and Characteristics of Pump-Jet for Underwater Integrated Motor Propulsor

On Hydrodynamic Design of Underwater Supercavitating High Speed Vehicle

CFD Analysis and Configuration Optimization of Jet Pump

Multi-objective Optimization of the Flush-Type Intake Duct for a Waterjet Propulsion System

Nozzle Optimization for Water Jet Propulsion with A Positive Displacement Pump

Design and Hydrodynamics Analysis of the Propulsive Mechanism of a Small Amphibious Robot

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Investigation on Optimization Design of High-Thrust-Efficiency Pump Jet Based on Orthogonal Method

Optimal Design of Inlet Passage for Waterjet Propulsion System Based on Flow and Geometric Parameters

Optimized Design of Steam Jet Pump